dji Matrice 200 Series V2 Информация о продукте - Страница 2

Просмотреть онлайн или скачать pdf Информация о продукте для Дроны dji Matrice 200 Series V2. dji Matrice 200 Series V2 8 страниц. Manifold 2 mounting bracket
Также для dji Matrice 200 Series V2: Краткое руководство по эксплуатации (15 страниц), Краткое руководство по эксплуатации (7 страниц), Руководство пользователя (12 страниц)

Disclaimer and Warning

Congratulations on purchasing your new DJI

product. The information in this

document affects your safety and your legal rights and responsibilities. Read this

entire document carefully to ensure proper configuration before use. Failure to

read and follow instructions and warnings in this document may result in serious

injury to yourself or others, damage to your DJI product, or damage to other

objects in the vicinity. This document and all other collateral documents are

subject to change at the sole discretion of DJI.

By using this product, you hereby signify that you have read this disclaimer

and warning carefully and that you understand and agree to abide by the terms

and conditions herein. You agree that you are solely responsible for your own

conduct while using this product, and for any consequences thereof. You agree

to use this product only for purposes that are proper and in accordance with all

applicable laws, rules, and regulations, and all terms, precautions, practices,

policies and guidelines DJI has made and may make available.

DJI accepts no liability for damage, injury or any legal responsibility incurred

directly or indirectly from the use of this product. The user shall observe safe and

lawful practices including, but not limited to, those set forth in this document.

Notwithstanding above, your statutory rights under applicable national legislation

are not affected by this disclaimer.

DJI is a trademark of SZ DJI TECHNOLOGY CO., LTD. (abbreviated as "DJI")

and its affiliated companies. Names of products, brands, etc., appearing in this

document are trademarks or registered trademarks of their respective owner

companies. This product and document are copyrighted by DJI with all rights

reserved. No part of this product or document shall be reproduced in any form

without prior written consent of or authorization from DJI.

In the Box

GPS Kit ×1

Hex Key ×1

Screws ×3

Introduction

The MATRICE

200 Series V2 GPS Kit comes with a built-in GPS module and

compass, which are required when a single upward gimbal or other payload is

used on the Matrice 210 V2 aircraft to obtain better GPS signal.

Usage

With the aircraft's rear facing towards you, follow the steps below to mount the

GPS kit to the right side of the aircraft.

1. Remove the right landing gear after unlocking the clamp.

2. Loosen the three screws on the mounting base to remove it. Keep the

mounting base separately for future use.