Arthur Grillo DPC200 Руководство по установке и эксплуатации - Страница 6
Просмотреть онлайн или скачать pdf Руководство по установке и эксплуатации для Контроллер Arthur Grillo DPC200. Arthur Grillo DPC200 16 страниц. Differential pressure controller, low pressure sensor with pi-control-mode
Также для Arthur Grillo DPC200: Руководство (7 страниц), Руководство по установке и эксплуатации (14 страниц)
INSTALLATION
3.
Installation
The differential pressure controller DPC200 is designed for wall mounting.
When selecting the installation site please note the following factors:
•
The mounting surface must be solid enough and vibration-free.
•
The environment has to fulfil the ambient climatic conditions as given in the technical
data.
CAUTION
NOTICE
3.1 Dimensions
All dimensions in mm.
3.2 Wall mounting
1.
Hold the DPC200 against the wall. Mark the mounting holes.
2.
Bore mounting holes for sufficiently dimensioned screws resp. dowels.
3.
Press in dowels.
4.
Put the screws through the tightening channels of the housing screws so that the
screws stick out on the backside of the housing.
5.
Place the device with the screws exactly onto the mounting holes with the dowels.
6.
Tighten screws.
6
Material damage
Read the manual carefully before installation and operation
Only experienced stuff may connect the device and bring it into
operation.
•
The device is position depended.
•
It is important that the assembly is vertical.
•
The DPC200 can be mounted on a wall.
Doc.-no.: DPC200_01_EN
Issue: 11/2015