dji PHANTOM Руководство - Страница 5

Просмотреть онлайн или скачать pdf Руководство для Дроны dji PHANTOM. dji PHANTOM 6 страниц. Led indicator description & faq
Также для dji PHANTOM: Краткое руководство по эксплуатации (17 страниц), Краткое руководство по эксплуатации (14 страниц), Краткое руководство по эксплуатации (8 страниц), Руководство по продвижению (6 страниц), Краткое руководство по эксплуатации (3 страниц), Краткое руководство по эксплуатации (3 страниц), Монтаж (2 страниц)

dji PHANTOM Руководство
A: This indicates that you have moved at least one TX sticks during system start up and self-check. Reboot the autopilot system.
Q: The aircra does not receive any satellite signals.
A: 1. Please check if there are buildings that could be blocking the satellite signal. GPS needs an open area to work.
2. Please check whether there are objects placed on the top of the PHANTOM, that could be blocking the signal to the satellite sensor.
Q: How do I determine that the GPS module is in working condition?
A: 1. When you connect to the assistant so ware, if it requests that you connect the GPS module, it means that the GPS does not work
correctly.
2. Put the TX switch "S1" to the top position, if there is a mode light blinking such as green single flash (or double flash), it means that the
GPS is working correctly.
3. A er power on, if you have seen the red light flashing one, two or three times indicating the number of satellites locked, it means that
the GPS works correctly.
Q: Unable to connect to the assistant so ware.
A: 1. The driver is not installed properly. Reinstall the driver.
2. The assistant so ware and firmware versions do not match. Upgrade the so ware or firmware.
3. If the LED indicator does not light solid Green, it is probably the wire that is damaged or a bad connection, or the LED module is broken.
If it is sure the LED is broken, please contact your dealer.
Q: The transmitter alarms when switched on.
A: 1. The throttle stick is not at the lowest position, pull the throttle stick to the lowest position.
2. The transmitter has a low battery, change the batteries in the transmitter.
Q: Flying time shortens.
A: 1. The battery is not in a good condition.
2. The battery is not fully charged.
3. Load weight increased.
4. The battery might be very cold (i.e. cold weather)
Q: LED indicator does work correctly.
A: Damaged LED module. Please replace it for a new LED module.
Q: Can I fly my Phantom with any WiFi enabled equipment?
A: No, the WiFi signal may interfere with the signal of the transmitter and affect your flight.
常见问题
Q: PHANTOM相关的说明书、调参软件等资源在哪里可以下载。
A: 在DJI网站(http://www.dji-innovations.com/)上PHANTOM的主页中的"下载"链接下你可以找到所有相关文件。
Q: 在哪里可以找到相关视频教程。
A: 在DJI网站(http://www.dji-innovations.com/)上PHANTOM的主页中可以找到相关视频教程。
Q: 从哪里可以了解"驱动程序和调参软件安装"、"飞行器调试及固件&调参软件升级"、"遥控器与接收机对码"、
" 遥控器控制模式更改"、"遥控器校准"、"安装相机框架与相机"和"智能方向控制飞行"等内容 。
A: 请从PHANTOM下载页面下载"高级篇手册"。
Q: 从哪里可以了解充电器和电池的相关内容
A: 请从PHANTOM下载页面下载"电池与充电器使用说明"。
Q: 系统初始化和自检查时闪灯不正确,最后四闪绿灯中有红灯出现。
A: 飞控系统不能正常工作。请联系您的代理商。
Q: 飞行器过程可能会出现的风险。
A: 请务必阅读说明书,在熟悉本产品之前请勿进行飞行,否则会出现严重的事故。
飞行器坠落、旋转的螺旋桨可能会伤到人和物。飞行器可能会不受控制甚至丢失。
Q: 系统初始化和自检查之后,如有 (
A: 1. 传感器误差过大。请连调参软件,进入"工具"->IMU校准,观看"IMU校准"视频教程,进行基础校准或高级校准。
2. 加速度计损坏。请联系代理商。
3. 传感器不工作。请联系代理商。
Q: 系统初始化和自检查之后,启动电机之前,如有(
A: 1. 如果飞行器被触动时出现,则为正常现象。
2. 如果飞行器静止时出现,则需要进行IMU校准。请连调参软件,进入"工具"->IMU校准,观看"IMU校准"视频教程,
进行基础校准或高级校准。
)出现。
)出现。