Akku Vision e-bike vision 10005 Руководство/Примечания по технике безопасности - Страница 6
Просмотреть онлайн или скачать pdf Руководство/Примечания по технике безопасности для Аксессуары для велосипедов Akku Vision e-bike vision 10005. Akku Vision e-bike vision 10005 9 страниц. For your e-bike vision powerpack, compatible to panasonic* next generation drive system with 36 v
Печатать страницуSafety notes for charging
Please pay particular attention to the following points when charging:
Connect the charger only to a suitable mains supply.
•
Do not charge NiCd, NiMh or primary cells!
•
Use the charger only with the appropriate PowerPacks of Akku Vision!
•
When not using for a longer period, disconnect the mains supply and also connected batteries.
•
The charging time varies depending on the battery's capacity and charger type.
•
Do not charge the battery below 0° and not above 45° C. The battery management system will not allow to
•
start the charging process.
Please charge your PowerPacks only under supervision and on a non-combustible surface (both battery and
•
charger).
The charger is designed for operation in ventilated, dry and dust-free environment. Never expose to rain or
•
extreme heat. Allow adequate air circulation.
Do not cover the charger, nor the battery.
•
Ensure that that the plugs and sockets of the charger are not damp or contaminated.
•
Do not touch plugs and sockets of the charger with wet hands.
•
Do not try to convert or disassemble the charger.
•
Before the charger is connected to the mains, please ensure that line voltage matches to the supply voltage
•
of the charger. The charger's needed voltage is indicated on its nameplate on the backside.
A charger with a damaged power supply cord or plug must not be connected to the electrical grid and must
•
promptly replaced or repaired by the E-Bike service center.
Penetration of water and moisture into the charger must be avoided in any case. Should this have happened,
•
power off the charger (by turning off the fuse) immediately. Disconnect the charger from the mains and let
it be checked by the Akku Vision service center.
A sudden temperature change from cold to hot, there could be condensation water on and in the charger.
•
In this case, wait for connecting to the mains until the charger is as warm as the room. Try to avoid this case
by storing the charger where you use it.
For maximum life of your battery, charge it only within 10° and 30° C temperature range.
Date October 2021
Version 01
Akku Vision - Manual PowerPack compatible to Panasonic* Next Generation 36V
*Panasonic is a trademark of the Panasonic Corperation
S. 6 / 9