FITNESS AUDIO DX6 Руководство по эксплуатации - Страница 6
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Приемник FITNESS AUDIO DX6. FITNESS AUDIO DX6 12 страниц. Single-channel three redundancy digital receiver
Печатать страницуDX6-PR
Single-Channel Three Redundancy Digital Receiver
Once the RX and TX units are paired they will remain so for subsequent uses. Pairing will be
automatic upon both units being powered on.
Tips for best results
1. For each use of the SYSTEM start with the RX and TX units fully charged.
2. Position the TX and RX with as few physical obstacles between them as possible. While the
System can overcome minor obstructions fairly well, a clear line-of-sight between the TX and
RX is always best.
3. Over-crowded Wi-Fi environments can make it challenging for the SYSTEM to find a clear
channel on which to connect. An over-crowded Wi-Fi environment will also limit the number of
Systems that can be used simultaneously in the same area. Consider these limitations when
choosing your location.
4. Close proximity to Wi-Fi or Bluetooth equipment can negatively affect performance. Avoid
operating the SYSTEM near such equipment whenever possible.
5. The System will automatically scan the 2.4 GHz environment each time it is powered on and
choose the best frequencies on which to connect. You can use this to your advantage; if you
know of a trouble spot because of its proximity to other 2.4 GHz equipment, turning on the
system in a trouble spot will allow it to better avoid frequencies that are already in use. If you
encounter an area that causes frequent drop outs while using the system, carry both system
units into the trouble spot, power off the units and then power them on again. When the units
pair up again they will avoid using any interfering frequencies in the area.
1. Press and hold the DX6-TF transmitter's "SYNC" button
located under the battery cover until it flashes on the
LCD Screen.
2. Press and hold the power button on the PR until the
signal LED flashes RED indicating pairing mode, then
release at which time the DX6-TF will synchronize and
the "SYNC" will disappear from the screen and display
Channel info instead.
3. Press and release the power button on the PR to
complete pairing lock. The signal LED will stop flashing
red and a second later will be a steady GREEN
indicating that it's connected.
5