Cleco Tools CellCore P2402KA Руководство по быстрой установке - Страница 8
Просмотреть онлайн или скачать pdf Руководство по быстрой установке для Контроллер Cleco Tools CellCore P2402KA. Cleco Tools CellCore P2402KA 16 страниц. Data transmission
Печатать страницу
3
Setting up the mPro200GC-AP
EN
3
Setting up the mPro200GC-AP
3.1
Prior to Initial Startup
To set up the controller, the following items are required:
•
PC
•
Ethernet cable
•
Software mProRemote Professional
•
Software LiveWire Utilities
•
Monitor with VGA connector, keyboard and mouse (optional)
1.
Download the mProRemote Professional and LiveWire Utilities software from the following website:
http://software.apextoolgroup.com/current-software-packages/pc-software/
2.
Install the mProRemote Professional software on the PC, see Document mProRemote Professional.
3.
Install the LiveWire Utilities software on the PC, see Document P2372JH.
4.
Set network settings from laptop/PC to i. e. 192.168.100.201.
3.2
Configuring the access point
In the factory setting, the IP address and the subnet mask of the controller are specified with a default value
(Ethernet 1):
Parameter
IP address
Subnet mask
Note
If installing more than one Series 200 Controller, each controller must have a unique IP address.
Connecting all controllers to the same network without changing the original IP address of
192.168.100.200 will create an IP conflict.
Assign a new IP address to each controller.
To configure the access point:
1.
Connect laptop/PC directly to a mPro200GC-AP using an Ethernet cable.
2.
Start mProRemote Professional on the PC.
3.
In the Remote Control tab in the Target input box, enter the IP address 192.168.100.200.
4.
Press Remote (TCP/IP).
→ A connection to the controller is established.
→ The user interface for the controller opens on the PC.
5.
Select Navigator > Utility > System Settings > Radio Frequency (RF) Configuration LiveWire/CellCore.
6.
Open the Wireless AP Configuration tab.
7.
Carry out the desired settings for the configuration of the access point.
8.
Press <Apply> to save the changes.
8
Default value
192.168.100.200
255.255.255.0
P2402KA | 2019-05
Apex Tool Group