Artillian 1RMTBWM Руководство по установке и эксплуатации - Страница 3

Просмотреть онлайн или скачать pdf Руководство по установке и эксплуатации для Стойки и подставки Artillian 1RMTBWM. Artillian 1RMTBWM 6 страниц. Artillian rops mounted tool bar wall mount

Печатать страницу

Attach the brackets to the wall per one of the

following methods as appropriate for the type

of wall construction:

Wood frame construction (finished or

unfinished):

The provided screws will hold securely in wood

studs. A pilot hole is not necessary, but use a

5/32" drill bit if desired.

Concrete or solid brick walls:

Use a Hammer drill with a 5/32" masonry bit

(INCLUDED) to drill at least 2-1/2" into the

wall. Clean the dust out of the pilot holes.

Install the provided screws into the pilot holes

(Do not use a hammer drill).

Hollow cinder block walls:

It is recommended to install wood studs onto

the block wall to distribute the load. Installing

directly onto the block wall may result in failure

of the fastener or the block.

If using a 2x4" stud as a strap, use longer 2-

3/4" concrete screws (NOT INCLUDED).

Drill 5/32" pilot holes through the stud and the

block with a hammer drill and masonry bit.

Metal Frame / Studs:

The provided screws will not hold securely. It is

recommended to drill through the center of the

metal studs and use a toggle anchor (NOT

INCLUDED).

Drill through both the drywall and metal stud

with the recommended drill for the anchor

(usually 1/2"). Install per the toggle anchor

manufacturer's instructions.

Enclosed Trailers:

Trailer walls are typically constructed of thin

plywood walls clad in metal or plastic on the

outside, and possibly drywall or paneling on

the inside. The provided screws will not hold.

1. Install the brackets with nuts and bolts (NOT

INCLUDED) through the trailer walls.

2. Install wood studs inside the trailer to hold the

brackets. Use the included screws into the

newly created studs. 2" studs (actual 1-1/2")

are recommended to have enough holding

strength.

CAUTION: Make certain that the screws do not

protrude through the outside surface of the

trailer walls.

KIT INSTALLATION

Fig. 3b (Bracket fasteners into concrete wall)

Fig. 3c (Bracket fasteners into cinder block wall)

Drill holes through

drywall and metal stud

per anchor instructions

Toggle Anchors

(NOT INCLUDED)

Fig. 3d (Bracket fasteners into metal stud wall)

Fig. 3e (Bracket fasteners into enclosed trailer wall)

3 of 6

5/32" pilot

holes, 2-1/2"

deep

5/32" pilot

holes thru

2-3/4" Concrete screws

(NOT INCLUDED)

Screws must

not protrude

thru outside

wall