Artillian 1RMTRK Руководство по установке и эксплуатации - Страница 2

Просмотреть онлайн или скачать pdf Руководство по установке и эксплуатации для Сельскохозяйственное оборудование Artillian 1RMTRK. Artillian 1RMTRK 3 страницы. Rops mounted tool rack

Печатать страницу

ATTACH TO MOUNTING BAR:

1. To install the tool rack, rotate both cam levers UP,

then place onto the Toolbar. See figure 1.

Note: if the Cam Lever Latches do not sit flush on the Toolbar, one of

the clamp plates may not have been fully open. Simply remove the

tool rack, rotate the cam levers up, and tilt the tool rack away from

you to ensure the clamp plates are fully open, then reinstall on the

Toolbar.

2. To secure the tool rack to the Toolbar, rotate both

cam levers DOWN until they cam over.

NOTE: For additional security, the tool rack can be locked to the

Toolbar by inserting a padlock through the holes in the mounting

bracket where shown. See figure 1.

To remove the tool rack from the Toolbar, rotate both

cam levers UP, then lift the tool rack.

FEATURES AND OPERATION

1. The 8 rubber clamps are intentionally staggered so

than an upper clamp does not interfere when trying

to pull the rubber strap from a lower clamp up and

inward onto the hooks. The end user may change

the stagger pattern if so desired.

2. The cam lever latches are factory installed in the

middle set of holes where shown in figure 2. At the

user's discretion, the latches can be relocated to

the set of holes marked "A" or "B". The entire plate

assembly can also be rotated 90 degrees if

preferred. In that case, utilize the holes provided in

location "C".

For optimal functionality, the cam lever latches are

factory assembled with some friction between the cam

lever and the housing. This ensures the cam lever

doesn't accidentally flip closed while the user attempts to

install it on the bar. If the cam levers loosen up over time,

simply tighten the nut and bolt that secure the lever to

the housing until the desired resistance on the cam lever

has been achieved.

FEATURES AND OPERATION

ENJOY!

rotate both cam levers up

to install the tool rack

padlock holes

Fig. 1 (attaching the tool rack)

Fig. 2 (optional cam lever latch locations)

2 of 3