Custom Crimp D100H SERIES Руководство по эксплуатации - Страница 4
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Электроинструмент Custom Crimp D100H SERIES. Custom Crimp D100H SERIES 12 страниц. Hydraulic hose crimper
Также для Custom Crimp D100H SERIES: Руководство по эксплуатации (13 страниц)
Печатать страницу
D100 SERIES QUICK START GUIDE
TO ASSURE ACCURATE CRIMP DIAMETERS FOLLOW THESE STEPS
BEFORE YOU USE THE CRIMPER FOR THE FIRST TIME
• Position the crimper on a sturdy surface in a will lighted area
• Check crimper calibration prior to initial operation
• Seat the Pressure Plate (flat plate) in the base of the crimper
• Place any D100 series die set on top of the Pressure Plate making certain
that the die set is firmly seated against the Pressure Plate.
Note: Do Not use Double Angle Die set for
calibration check
• Place the Compression Ring
on top of the die set in the order
shown and slide the pusher onto
the ram.
• Set the Micro-crimp adjuster
as follows:
Standard Micrometer: "100"
"DC" Micrometer: "95"
Metric Micrometer: "0"
• Bring the Pusher into contact
with the Compression Ring and
continue to apply force until the die set is fully
closed and the white line is flush with the surface of
the micro crimp adjuster as shown.
• Note that for the D101S series, the electric switch
will shut off the power source at the point at which
the die set is fully closed and the pump starts to
build pressure.
• If the white line is not just visible as shown or the
pump does not shut off at the point where the die set is fully closed, the
crimper must be recalibrated. See calibration instructions.
Page
4