Custom Crimp SM 300 Руководство - Страница 8

Просмотреть онлайн или скачать pdf Руководство для Электроинструмент Custom Crimp SM 300. Custom Crimp SM 300 19 страниц. Hose skiver

HOW TO ADJUST SKIVING DEPTHS ON OD TOOL

1. Place the hose on to mandrel and slide the hose up to the

cutting inserts.

2. Loosen the 3/8-16 hex head bolt with a 9/16" wrench.

3. Slide the adjustment bars to a position just above hose wires

(as shown).

4. Tighten the 3/8-16 hex head bolt with a 9/16" wrench.

5. Skive the OD of a hose to check how close to the wire you are.

6. To make a small adjustment loosen the hex head bolt again

and use the set screw (as shown) for minor adjustments.

Note: The scale can be used for reference.

Note: Moving the set screw in will remove more rubber.

Note: Moving the set screw out will remove less rubber.

7. Continue to make adjustment until skive meets the hose and

ﬁ tting manufacturer's requirements.

8. Make sure that all set screws and hex head bolts are tight.

HOW TO SETUP MULTIPLE SKIVING DEPTH ON

OD TOOL

Note: This is if the same tool will be used to skive diﬀ erent

wire hoses on the same size hose.

1. Follow the initial OD skiving tool setup to set up each adjustment

arm.

For example: -4 wire hose, and the other adjustment arm for

-6 wire hose (as shown).

2. When skiving the larger wire hose remove the smaller wire

cutting insert (as shown).

3. Place the smaller OD insert in when needed.

-4

-6