Custom Dynamics PB-DS2-14-CON Инструкции по установке
Просмотреть онлайн или скачать pdf Инструкции по установке для Аксессуары для мотоциклов Custom Dynamics PB-DS2-14-CON. Custom Dynamics PB-DS2-14-CON 2 страницы. Led turn signals
Печатать страницуWe thank you for purchasing the Custom Dynamics® ProBEAM® Dynamic Strips™ LED Turn Signals! Our LEDs offer mainte-
nance free service and higher visibility. Our ProBEAM® product line utilizes the latest technology and automotive grade com-
ponents to ensure the highest level of reliable service. Custom Dynamics® offers one of the best warranty programs and cus-
tomer support in the industry. If you have any questions during the installation of this product please call us at 1(800) 382-
1388.
Part Numbers:
PB-DS2-14-B (Black)
PB-DS2-14-C (Chrome)
PB-DS2-14-CON (Contrast Cut)
Package Contents:
- ProBEAM® Dynamic Strips™ (pair)
- 4" Black Tie Wraps (8)
- 5/16"x 1-1/4" Button Head Bolt(4)
- Finished Flat Washer (4)
Fitment: All 2014 -2022 Street Glide Models
(including CVO) and 2014-2022 FLHT Models
Without Driving Light Buckets
ATTENTION
Please read all Information below before Installation
Warning:
Disconnect negative battery cable from battery; refer to own-
er's manual. Failure to do so may result in electrical shock, injury, or fire.
Secure negative battery cable away from positive side of battery and all
other positive voltage sources on vehicle.
Safety First:
Always wear appropriate safety gear including safety glasses
when performing any electrical work. It is highly recommended that
safety glasses be worn throughout this installation process. Be sure
vehicle is on level surface, secure and cool.
Cleaning: Take special care in cleaning the finish. Use only a non-
abrasive cleaner and a fine microfiber cloth to remove dirt or debris.
Never use abrasive polishes or cleaners as these can scratch the finish.
Questions? Call us at: 1 (800) 382-1388 M-TH 8:30AM-5:30PM / FR 9:30AM-5:30PM EST
Custom Dynamics® ProBEAM®
Dynamic Strips™ LED Turn Signals
Installation:
1. Remove the 1/2" nuts that secure the turn signal assembly to the
fork shown in Picture 1. Pull assembly away from the fork to re-
veal the black wiring connector as shown in Picture 2.
1
2. Unplug the connector by pushing in on the tab located on the male
side of the connection as shown in Picture 3. Push the tab and pull
apart both sides at the same time. Remove the turn signal assem-
bly from the bike completely.
Installation Instructions
02-2022