Artison LRS-W Руководство по установке - Страница 4

Просмотреть онлайн или скачать pdf Руководство по установке для Динамики Artison LRS-W. Artison LRS-W 8 страниц. Surround / in-wall surround

This section will guide you through the installation of the surface mount Artison Surrounds.
Please refer to the diagrams on the opposite page.
1. Positioning Guidelines
a. The LRS should be mounted behind, beside, or above the primary seating area.
b. When wall mounting the LRS should be mounted at a height ¾ of the total wall height
(i.e. For a 10' high wall, mount LRS 7.5' high).
c. When ceiling mounting the LRS pair should be mounted at least 6-8 ft. apart
horizontally.
d. Keep the LRS at least two feet away from any corner when possible.
e. NOTE: These are only recommendations; your specific room application will
determine the final height and placement of the surround speaker mounting.
2. Artison LRS are marked Left or Right on the back of the speaker. To ensure the correct dipole
sound staging, keep the corresponding speaker on the correct side of the listening area. Left
or Right is determined when facing the display screen.
3. Place the LRS on its flat back you will see four screw holes in the corners of the baffle. Using
the supplied 3 mm Allen Wrench, remove the four 3 mm Allen Head screws located in these
holes. These screws secure the attached mounting plate. Removing these screws will detach
the plate from the speaker. There is one mounting plate per speaker. See Figure 1.
4. The large rectangular hole in the wall mount plate should be located towards the bottom when
mounted; this is for the speaker wire to pass through to the mounting plate to the terminals of
the speaker. See Figure 2.
5. To install use the four holes in the mounting plate closer to the center of the part, indicated
with red arrows in Figure 2. For a secure installation, use all four mounting holes per plate. Be
sure to use the appropriate hardware and anchors for your application. NOTE: Do not over
tighten these four mounting screws, this will warp the mounting plate and make installing the
LRS cabinet to the plate unnecessarily difficult.
6. Pull the speaker wire through the square opening in the mounting plate and connect to the
corresponding positive (Red) and negative (Black) speaker terminals.
7. Using 4 x 3 mm Allen Head screws per speaker and 3 mm Allen Wrench, attach the LRS
cabinet to the mounted plates.
8. Install the LRS Grilles. See Figure 3.
LRS-B & LRS-W
4