Artison Sound Surface 40 Руководство по установке - Страница 4
Просмотреть онлайн или скачать pdf Руководство по установке для Динамики Artison Sound Surface 40. Artison Sound Surface 40 11 страниц. Invisible speaker
2) Mark the Wall/Ceiling
1.
Use a stud locator instrument or other approach to mark the location of studs and other items that
may obstruct the installation of the speaker. See Figure 2 below.
2. The following clearances are required to install the speaker (with no obstruction from studs or other
wall fixtures): (9
Figure 2.
3) Cut the Drywall
1.
Place the Drywall Scoring Template onto the wall or ceiling where the speaker will be installed. As
described in step 2 above, ensure no studs or other obstructions are directly behind the wall where
the cuts will be made (Figure 3 above shows the clearances required).
2. Trace a thin line along the two longest sides of the template. The template incorporates a pencil
illustration
3. Trace a thin line along the two slits at the top and bottom of template. These slits are also referenced
with a pencil illustration .
IMPORTANT! Do not mark a line along the top and bottom edges of the template. The cut line should be
made using the slits at the top and bottom of template.
4. Mark the six speaker mounting holes located at the top and bottom of template.
5. Remove template.
6. With a utility knife and straight edge ruler, score lines made in steps 2 and 3 above. Use care to cut
through the PAPER LAYER only.
7.
With a drywall saw, cut the drywall on the INSIDE of the utility knife cut made in step 6 above. This
ensures the clean, sharp edge of the cut made with the utility knife is maintained. See Figure 5 below.
8. Insert the face of the speaker into the hole cut in step 7 above (dry fit). There should be about .079 in
(2 mm) of clearance around the perimeter of the speaker. Set speaker aside.
3 /
9. Drill a
inch hole for each speaker mounting hole made in step 4 above.
16
Figure 4.
Surface 40/80 Speakers | 009-1656-01 | 180731
Copyright 2018 Savant Systems, LLC
Installation - Retrofit
1
1
3 /
/
/
in x 26
in x 3
4
2
8
where the lines need to be made. See Figure 4 below.
in) (248 mm x 675 mm x 80 mm). See Figure 3 below.
26 ½ in
Figure 3.
Figure 5.
4 of 11
45 Perseverance Way, Hyannis, MA 02601
9 ¾
in
3
in
Speaker
Clearances required
from obstructions
in wall
Pencil Line
Cut INSIDE the
utility knife cut
line with drywall saw
Savant.com
| 508.683.2500