DK-TEC HNDK Руководство пользователя - Страница 12
Просмотреть онлайн или скачать pdf Руководство пользователя для Сельскохозяйственное оборудование DK-TEC HNDK. DK-TEC HNDK 15 страниц. Woodchipper for tractor
Печатать страницуWhen
Daily
At every 40 hours or weekly
At every 100 hours
Annually
Maintenance
•
By following e the service and maintenanceprogram of your chipper, you will enjoy
many years of trouble-free operation.
•
When maintaining the chipper, it is a good idea to loosen
can.
Clean the roller and tighten
Maintenance of the shaft
•
The PTO shaft should telescope lightly and covers rotate freely on the shaft at all times.
Annual dismantling, cleaning and lubrication is recommended to ensure that all
components function as intended. For the maintenance of the shaft, this procedure should
be followed:
1. Remove the shaft from the chipper and pull
2.
a screwdriver, turn the latch's spout at each end. There are 2 for each cover.
Using
3. Pull the shaft out of the plastic tubular covers.
4. Using a solvent, clean
to each end.
5. Use a solvent to wash the grooves on each end. Also clean each end and apply a thin layer
of fat to each groove.
6. Insert the shaft into their respective covers and align with the holes.
7. Insert the tabs through the holes and insert it into the groove.
8. Turn each stud to secure the shield to
9. Check that each shield rotates freely on the shaft.
10. Reassemble the shaft.
11. Check that
shaft rotates easily in the telescope.
the
12. Replace parts that are damaged or worn.
13. Install the shaft on the chipper.
What should be done?
Lubricate PTO shaft
1. Lubricate the telescopic section of the PTO
shaft
2. Check the sharpness of the blades:
a. Flywheel
b. Desktop
Remove the blades and replace them as needed
1. Grease all bearings
2. Lubricate rotor bearings
IMPORTANT – do not over-lubricate !
Clean the chipper
the
bottom damper again.
the
parts of the telescopic ends and apply a bright layer of grease
both
shaft.
the
bottom damper so
the
shafts apart.
02/2020
the roller
that
10