DK-TEC SPCPR150 Руководство пользователя - Страница 7

Просмотреть онлайн или скачать pdf Руководство пользователя для Чиппер DK-TEC SPCPR150. DK-TEC SPCPR150 12 страниц. 15 hp wood chipper with electric start

Печатать страницу

01/2020

Transport position

Manual transport position

2 . Before operating the machine

Check that the machine is firmly on the ground and cannot tip in any way. The danger zone on the

outlet pipe of the machine must be observed to avoid serious personal injury from chips being

thrown out of the outlet pipe. Chips can be thrown a distance of 12 meters, so spectators must

stay behind the throwing direction or at least 12 meters away from the exit pipe.

Before using the machine for the first time, check the maximum engine speed by screwing in /

out the screw that controls the position of the throttle so that it is positioned as shown in the

drawing.

After the first hour of use, check that the bolts on the knives and the counter knife are tight and

that the distance between the knife and the counter knife is 0.5 mm (half a millimeter). If

necessary, adjust and tighten the bolts.

3 . Starting and operating the machine

Start the engine at half throttle and let it warm up for approx. 3 minutes. The engine is then set to

full throttle. (Fig.9, 10)

Insert the branches into the entry tube and when you feel them being pulled in by the rotating

blades, let go of the branches. Do not continue to hold the branch, as the branch will be pulled

down into the machine by itself. The side branches with a diameter of more than 3 cm must be

sawn or chopped separately.

Warning!

In case of emergency or in case of any doubt, press the emergency stop (the red button) which is

nearby

the engine (Fig.11)