DK2 Power OPG777 Руководство по сборке - Страница 11
Просмотреть онлайн или скачать pdf Руководство по сборке для Шлифовальный станок DK2 Power OPG777. DK2 Power OPG777 16 страниц. Stump grinder
Печатать страницу
QUICK START SETUP
•
ADD 10W30 OIL TO ENGINE
•
ADD GAS
•
RAISE UP KICK STAND
•
TURN KEY ON
•
TURN GAS ON
•
HALF THROTTLE (CHOKE OPTIONAL FOR COLD STARTS)
•
TIP THE UNIT BACK WITH THE CUTTERS OFF THE GROUND
•
PULL START THE ENGINE
STUMP CUTTING
•
ENGINE ON HIGHEST SPEED
•
HOLD TIGHT ON BOW HANDLE WITH BOTH HANDS
•
LOWER CUTTERS INTO TOP OF STUMP, CUT 3.5IN WIDE TO CUTTER DEPTH
•
RAISE CUTTERS UP AND MOVE OVER FOR NEXT CUT, REPEAT
•
PIVOT CUTTERS FROM SIDE TO SIDE TO FACE OFF REMAINING STUMP
TROUBLE SHOOTING
• ENGINE WON'T START
•
TURN KEY ON – CHECK ENGINE OIL LEVEL - CHECK GAS LEVEL
•
UNPLUG KEY SWITCH – IF ENGINE STARTS REPLACE THE KEY SWITCH.
•
FOLLOW YOUR ENGINE MANUAL FOR FURTHER TROUBLE SHOOTING.
• UNIT VIBRATES
•
CHECK YOUR CUTTERS FOR MISSING OR LOOSE TEETH.
•
CHECK YOUR CUTTER WHEEL PILLAR BEARING MOUNTING BOLTS.
• POWER LOSS AT CUTTER WHEEL
•
CHECK YOUR BELT TENSION – SLIPPING BELTS CAUSE POWER LOSS.
•
WORN BELTS - REPLACE
•
BELT TENSION SHOULD BE SET AT .25 INCH MOVEMENT ABOVE AND
BELOW BELT NORMAL POSITION.
•
CHECK YOUR 4 ENGINE MOUNTING BOLTS, LOOSE ENGINE BOLTS WILL
CREATE LOOSE BELT TENSION.
TROUBLE SHOOTING GUIDE
11