Alula Connect+ Краткое руководство по эксплуатации - Страница 2
Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Система безопасности Alula Connect+. Alula Connect+ 8 страниц.
Также для Alula Connect+: Руководство по настройке оборудования (2 страниц)
Печатать страницу
Figure A
Unpack the Connect+ Hub with your new
1
security system (see figure A above). We have
already set up a new security account on your
behalf. You will not need to modify the Hub
communications or the sensors provided in the
box, each sensor is already enrolled and will
communicate with and through your Connect+ Hub
after you provide power and Internet connections.
2
Find a location for the panel, keeping in mind
it needs AC power and a local network connection.
The long-range, encrypted wireless receiver in
Connect+ provides coverage for all sensors and
devices when placed in a central location on-site.
To maximize transmission range of Connect+
• M
iddle of building
• A
bove ground level
• P
rovide 6-foot clearance to the Wi-Fi router,
appliances and ducts (Figure B)
POTENTIAL FOR INTERFERENCE
Figure B
Mount the panel by sliding it downward into the
3
table-top base.
Page 2
Power up the panel by
4
inserting the power supply barrel
into the power jack on the side of
Connect+. Route the power cable
under the strain relief peg (Figure
C). In the U.S.A., use the outlet
cover plate screw to fasten the
power supply to the wall outlet.
Ensure the 110V wall outlet is
unswitched, with constant power.
5
Connect the panel to the Internet
its Ethernet port to the home router. Alternately, if
you ordered your Connect+ with a Wi-Fi expansion
card, we have already installed it - using the Wi-Fi
approach requires enrollment into the home Wi-Fi
router. Hold the Enroll/WPS button on Connect+
until it beeps twice and then press the WPS button
on your Wi-Fi router.
6
Confirm the top 5 LED's on Connect+ are green
before placing your sensors (Figure D).
Figure D
IN THE BOX
1. Installation references
(for professionals)
2. Connect+ Hub
3. Table top base
4. 12V power supply
5. 6' Ethernet cable
6. Cover screws
Figure C
Connections
Enroll/WPS
Ethernet Port
Power Jack
Power Strain
Relief
by wiring
Power
Pulsing - AC power connected
Off - AC power is removed
Network Connectivity
On - Connected
Off - No Connection
Central Station Connectivity
On - Connected
Off - No Connection
Alula Platform Connectivity
On - Connected
Off - No Connection
Arming Status*
Green - Disarmed
Red - Armed
Trouble
On - System trouble detected
Off - No system trouble
RF Activity
Flickering - Receiving sensor
data
System Firmware Update LED
On - No update needed
Blinking - Update in progress
Off - No connection