Alula RE614-Au Краткое руководство по эксплуатации - Страница 7
Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Дымовая сигнализация Alula RE614-Au. Alula RE614-Au 13 страниц. Smoke alarm connect+ encrypted
Печатать страницуMaintenance and Power Supply Monitoring",
then contact Customer Assistance at the nearest
address given at the end of this leaflet. If it needs
to be returned for repair or replacement put it
in a padded box with the battery disconnected.
Send it to "Customer Assistance" at the nearest
address given on the Alarm or in this leaflet. State
the nature of the fault, where the Alarm was
purchased and the date of purchase.
6. Installation
Installation Procedure
1. Select a location complying with the advice
in Section 2.
2. Lift off the mounting plate from the Smoke
Alarm.
3. Place the mounting plate on the ceiling
exactly where you want to mount the Alarm.
With a pencil, mark the location of the two
screw holes.
4. Taking care to avoid any electrical wiring in the
ceiling, drill holes using a 5.0mm drill bit through
the centre of the marked locations. Push the
plastic screw anchors provided into the drilled
holes. Screw the mounting plate to the ceiling.
Figure 5
ROTATE UNIT ANTI-CLOCKWISE
UNIT WILL NOT TWIST OFF - IT MAY BE
TAMPERPROOFED - SEE FIGURE 8
5. Insert the battery or batteries as per the
Quick Start Guide, ensuring the orientation
is correct. If the battery is already installed in
your Alarm just pull the battery tab to power
the Alarm.
6. Carefully line up the Alarm on to the
mounting plate, gentle press home and twist
clockwise.
Install all the other Alarms similarly.
7. Press the Test button on each Alarm to ensure
that the Alarm works (see Figure 6).
Figure 6
Smoke Alarm
Tamperproofing the Alarm
The Alarm can be made tamperproof to prevent
unauthorised removal of the Alarm.
Break off the small pillar on the base as shown
in Figure 7a.
To remove the Alarm from the ceiling it is now
necessary to use a small screwdriver, to release
the catch (push catch towards the ceiling) and
then twist off the Alarm (see Figure 7b).
Figure 7a
- How to Tamperproof
Figure 7b
- How to Remove
PUSH UP CATCH & TWIST
ALARM ANTI-CLOCKWISE TO REMOVE
If necessary it is possible to further secure
the Alarm by using a No.2 or No.4 (2 to 3mm)
(1/8") diameter - not supplied) self tapping
screw 6 to 8mm (1/4") long (see Figure 7d), to
firmly lock the Alarm and its mounting plate
together (see Figure 7c).
7
BREAK OFF
SMALL PILLAR