CUTRA Wondercutter Руководство по эксплуатации - Страница 4

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Фреза CUTRA Wondercutter. CUTRA Wondercutter 10 страниц.

power will provide maximum performance.

- The Wondercutter will provide maximum performance when the charger is plugging into an

outlet.

- If the device is not fully charged, the cutting power will be reduced.

- A loose setscrew will cause the Wondercutter to overheat and it may eventually cause damage.

Properly tighten the setscrew for safety.

- Properly attached the Wondercutter when carrying around the waste for mobile use.

- Follow the instructions to correctly install the blade to the handle.

- Fully charge the Wondercutter before initial use or after long periods of nonuse.

* Precautions

- Ultrasonic wave cutter cuts better than the normal cutter, so use caution.

- Wear necessary equipment including safety glasses.

- Wear safety gloves when operating the Wondercutter.

- Wear proper clothing when using the Wondercutter.

- Be aware of potential fumes as a result of the cut and wear protective ventilation gear when

necessary.

- Keep the workplace clean and well lite. .

- Turn off the main power button when not using the Wondercutter and return the handle to

the main body. When putting the handle back into the main body, be sure to center the working

button at 12 o'clock on the receptacle. The interior of the receptacle for the handle has an

indention for the handle button.

- Do not turn the Wondercutter on when the handle is inside the main body receptacle.

- Properly secure the material to be cut. - Do not cut metal or glass with the Wondercutter.

06 Product management

Hexagon wrench

Blade fixing screw

Attention

- Be careful when using the blade.

- The 40,000 vibrations per second rises the temperature due to friction and can make the

Wondercutter very hot, including the blade, collet, and setscrew. Avoid touching when hot..

- Reset the Wondercutter if performance is diminished.

1. Turn off the Wondercutter before changing the blade and tightening the setscrew.

Use a .6N torque wrench to tighten the setscrew. Only us a high quality wrench. The setscrew can be

used for approximately 20 times.

2. Be sure to reset the Wondercutter after changing the blade.

3. To reset the Wondercutter, press the button on the handle and the power button on the main body

simultaneously for 1 to 2 seconds

The cutter assembly is automatically detected and the sensor beeps with LED light on for a second and

the Wondercutter turns

off. After a second beep, the Wondercutter will turn on again. The 4 LED

lights on after the first beep indicates the Wondercutter was properly reset. If the 4 LED lights are not