Cutter Industries Pneumatic Auto Cutter IV Руководство пользователя - Страница 2
Просмотреть онлайн или скачать pdf Руководство пользователя для Фреза Cutter Industries Pneumatic Auto Cutter IV. Cutter Industries Pneumatic Auto Cutter IV 4 страницы. For wire and hard tubing
Печатать страницуSET UP
Secure the Cutter to the Bench
Insert two 1/4"-20 set screws into the bottom of the base
plate (front & back center) for permanent or semi-permanent
attachment to the workbench.
NOTE: When the automatic cutter is plugged into a 120v power
source, it is always on. If left plugged into a 120v power source,
the machine goes into Sleep Mode after 30 minutes of inactivity
and the LED will go out. To resume, press any key. The memory
will be retained.
Calibrate Cut Length
Some materials or sizes may cut longer or shorter than the
programmed length due to their different compression between
the feed rollers. The variance will always repeat within 1%.
• Run a test piece (programmed to desired length) to
determine length variance.
• Reprogram for longer or shorter length compensating for
the length variance.
The default length mode always comes on in U.S. Mode (inches).
The default decimal point always comes on the 00.0 position.
Load (Insert) Material
For material over 0.2" diameter, remove the inlet feed guide.
(Use needle nose pliers)
• Press down on the tension arm located on the rear left side
of the machine.
• Insert material through the inlet hole just forward from the
tension arm.
ALWAYS insert material until it is visible at the exit side of the
machine.
User Guide for the Pneumatic Auto Cutter IV
FAILURE TO USE CLEAN DRY AIR WILL VOID WARRANTY
OPERATION
Program a Batch Run
1. Set Length Mode (English/Metric)
• To change to metric (cm), press the English/Metric switch
through the small hole in the lower left of the face plate.
This is best done with a paper clip, pencil, etc.
• In English (U.S.) mode, length advances in 0.2 inch increments.
• In Metric mode, red light appears, length advances by 0.5 cm.
2. Set the Decimal Point
• To shift the decimal point to the right (000.)
Hold Length & press Run
• To shift the decimal point to the left (00.0.)
Hold Length & press Run
3. Set the Batch Quantity
• Press the buttons marked Set Right , Set Center , or Set Left
to set desired quantity.
• Each time you press one of these buttons, the display
advances from 0 through 9.
4. Set the Batch Length
• Hold the Length button while pressing the Set Right ,
Set Center , or Set Left buttons.
• Each time you press one of these buttons, the display
advances from 0 through 9.
Start a Batch Run
• Press Run.
(The display will show the remaining quantity to cut.)
Pause a Batch Run
• Press Run. The batch run will pause.
(The display will NOT blink.)
Resume a Batch Run
• Press Run to resume.
End of Batch Run
• Operation stops automatically.
(LED will display "0" blink quickly.)
Repeat Batch Run
• Press Run to clear the display and reset.
• Press Run again to start another batch with the same settings.