Cutting SQ80C1 Руководство по эксплуатации - Страница 5
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Промышленное оборудование Cutting SQ80C1. Cutting SQ80C1 7 страниц. Pipe threading machine
Печатать страницуInstalling dies
(Fig 2)
1. Place Self-Opening Die Head flat on bench with
numbers UP.
2. Make sure trigger assembly is released.
3. Loosen clamp lever.
4. Pull lock screw out of size bar slot so that roll pin in
lock screw will bypass slot. Position size bar so that
index line on lock screw is all the way to the end of
REMOVE DIES position.
5. Remove dies from die head.
6. Insert new dies to mark. Die numbers 1 through 4
must agree with those on die head.
7. Rotate cam plate until roll pin on lock screw can be
positioned in slot. In this position dies will lock in die
head. Make sure roll pin points toward end of size bar
marked REMOVE DIES.
8. Adjust die head size bar until index line on lock
screw is aligned with proper size mark on size bar.
(For bolt threads, align index line with BOLT line on size bar.)
9. Tighten clamp lever.
10. If oversize or undersize threads are required, set the index line in direction of OVER or
UNDER size mark on size bar.
Threading Pipe
1. Swing cutter and reamer to UP position.
2. Swing die head to DOWN position with throwout lever set to CLOSE position.
3. Switch on to start machine.
4. Turn carriage handle to bring dies against end of pipe. Pressure on handle will start dies.
5. Self-Opening Die Head (Figure 3 & 4) – When die head end of pipe contacts trigger,
throwout lever is automatically opened on tapered threads.
Fig 3
Pipe threading starts.
6. Turn off switch and turn carriage handle to back die head off.
Fig 2
5
Fig 4
Automatic
trigger
off
when
threads
length meets.