ALUZ A1-ZIBI-PVT-RGBW Руководство - Страница 8
Просмотреть онлайн или скачать pdf Руководство для Осветительное оборудование ALUZ A1-ZIBI-PVT-RGBW. ALUZ A1-ZIBI-PVT-RGBW 11 страниц. Pivot rgbw
Печатать страницу1
Determine number of louvers needed. Louvers are available in 1' increments.
Specify total length of reflectors needed.
2
Position louvers on luminaires.
Set Screw
3
Install 3 set screws on each louver to secure in place.
Do not over-tighten set screws
Set Screw
1170 N Red Gum St, Anaheim, CA 92806
aluz.lighting
© ALUZ All Rights Reserved. ALUZ reserves the right to make changes or withdraw specifi cations without prior notice.
A1 Series | Surface
ZIBI Pivot RGBW
(A1-ZIBI-PVT-RGBW)
866.ALUZ.LTG | 714.535.7900
4
If applicable, connect disconnects between luminaires. Slide shrink tube over
connectors and apply heat. The shrink tube will shrink down, sealing the
connectors. Apply silicone around sealed connectors for a stronger seal.
5
Mount luminaires at least 12" away from the wall.
Page 8 of 11
Louver (A1-ZIBI-PVT-LVR)
Shrink Tube
2"
Apply Heat
12"
Min. from Wall
Installation Instructions
4 / 29 / 2022 / Rev 2