ALUZ A8 Series Руководство - Страница 2
Просмотреть онлайн или скачать pdf Руководство для Осветительное оборудование ALUZ A8 Series. ALUZ A8 Series 2 страницы. Tape
Также для ALUZ A8 Series: Руководство (12 страниц), Руководство (14 страниц), Руководство по установке (13 страниц)
Печатать страницу
1.5"
X
1.5"
Dry Continuous Connector
20/3 Gauge Wire
(A8-CC-3P-DRY-X)
X = Specify Length, 3" Default
1170 North Red Gum Street, Anaheim, CA 92806
aluz.lighting
© ALUZ All rights reserved. ALUZ reserves the right to make changes or withdraw specifi cations without prior notice.
ZOMU SOLDERING GUIDE
1
Cut lightstrip to desired length. Include both sets of solder pads by
cutting to the left or right of designated markings, allowing more
space for soldering.
2
Prepare wires by stripping 1/8" from the end of each wire, then tin
the tips of the wire with solder. Apply heat to stripped portion of
wire, then add a small amount of solder until stripped portion of
wire is fully covered in solder.
3
Solder lead wires to solder pads on the end of lightstrip.
• Solder the Brown wire to the pad marked "+".
• Solder the White wire to the pad marked "W".
• Solder the Yellow wire to the pad marked "WW".
Note: Solder iron not to exceed 720°F. Heat joint with tip of iron.
Heat both the solder pad and the wire. Add a small drop of solder
on the tip of solder iron to transfer the heat to joint quickly; it
should melt and flow smoothly, covering the wire and pad.
Remove iron once enough solder has been added to the
components. Allow 5 seconds for the joint to cool.
0.50"
Note: Appearance of lightstrip may differ from example shown.
Refer to wiring diagrams before soldering any wires.
866.ALUZ.LTG | 714.535.7900
A8 Series | LED Tape
CONNECTOR Dry Continuous Connector
(A8-CC-3P-DRY)
1
After soldering is completed, make connections between connectors
by plugging the male and female disconnects together.
2
Position connectors as needed.
This document is issued in strict confidence on condition that it is not used as
a basis for manufacture or sale and is not copied, reprinted, or disclosed to a
third party either wholly or in part without the prior written consent of ALUZ.
CONNECTORS
Installation Cut Sheet
Page 2 of 2
3 / 7 / 2022 / Rev 0