ALUZ A8-ZIZA-STN Руководство - Страница 11

Просмотреть онлайн или скачать pdf Руководство для Осветительное оборудование ALUZ A8-ZIZA-STN. ALUZ A8-ZIZA-STN 12 страниц. Led tape

Measure area where luminaire will be installed. Use a laser line to create

a reference line along installation area, ensuring consistent alignment of

mounting clips. Mark location where each mounting clip will be installed

along reference line.

Mark location where mounting clips will be installed.

Note: The number of required mounting clips differs for dry and wet location

products. Verify number of mounting clips is appropriate for installation

environment before installing. Do not install luminaires with inadequate

number of mounting clips.

Lay mounting clips along reference line and pre-drill using an appropriate

drill bit for surface and screw size. Recommendation: 8/32 x 1" screw.

Note: Allow 0.25" clearance for lateral expansion of assembled mounting

clips.Only install mounting clips on flat, even surfaces.

Screw mounting clips to surface, then snap extrusions into mounting clips.

Note: Ensure extrusions are aligned. Misalignment will prevent lens from

snapping in.

Screw mounting clips to surface, then snap luminaires into mounting clips.

1170 N Red Gum St, Anaheim, CA 92806

aluz.lighting

A8 Series | LED Tape

ZIZA Standard

(A8-ZIZA-STN)

Install lightstrip into extrusions

Remove adhesive backing

866.ALUZ.LTG | 714.535.7900

If applicable, connect disconnects between luminaires or solder connectors

using the steps from Application Guidelines.

Install lens int o extrusion, overlapping where two extrusions meet. Plan

your cuts so that the lens will always overlap where two extrusions meet.

Overlapping lenses helps keep extrusions aligned and prevents light leaks.

Two extrusions meet

Perform a continuity test before connecting luminaire to power source.

Page 11 of 12

Mounting Fixture (Wet Location

Unassembled Mounting Clips)

Lens overlapping

Installation Instructions

4 / 11 / 2022 / Rev 1