Alvarado WATCHMAN Руководство по установке - Страница 4
Просмотреть онлайн или скачать pdf Руководство по установке для Турникеты Alvarado WATCHMAN. Alvarado WATCHMAN 10 страниц. Collision avoidance system
Печатать страницу
Installation Instructions
Battery Installation
NOTE
Battery installation is only applicable to battery-
powered models. For AC-powered models, skip to
the Placement and Mounting section below.
1. Remove the packaging from both end caps.
2. Locate the master side end cap on the opposite end of the
Watchman decal [Figure 3]. Using a 5/32" Allen wrench,
remove the screw securing the end cap to the tube.
3. Remove the end cap. Locate the thumb screw on the plastic
bar used to keep the battery packs in place [Figure 1].
4. Loosen the thumb screw and swing the plastic bar to the
side to gain access to battery packs [Figure 2].
5. Disconnect the (2) battery pack connectors and slide out the
battery packs from the end cap [Figure 2].
6. Insert (8) C cell batteries into the battery packs, ensuring
correct battery polarity. Make sure batteries are fully
inserted into the battery packs.
7. Return the battery packs to the end cap and reconnect the
(2) battery connectors. Swing the plastic bar back into place
and tighten the thumb screw.
8. Using a 5/32" Allen wrench, reinstall the end cap.
Placement and Mounting
CAUTION
Adhere to the following placement guidelines:
•
Verify the structural integrity of the object(s), i.e. joists, to which the Watchman will be suspended.
To provide enough warning time to avert a collision, the Watchman must be placed at a sufficient distance in front
•
of the object being protected to allow the forklift driver sufficient time to react and stop after Watchman activation.
What a sufficient distance is depends on the application where the Watchman is being used. Relevant factors
include the object being protected, the traffic pattern of the facility, available hanging space, and forklift operating
speeds. For applications where the Watchman will be placed in front of a roll-up door, locating the Watchman a
minimum of 4' in front of the door is generally an appropriate distance.
•
Place the bottom of Watchman's tube a minimum of 2" below the object or surface being protected.
•
Ensure the suspension cable angles are between 90° and 135° [Figure 3].
Left End Cap
(Master Side)
Page 4
PID1244R6-2
90°
135°
For Assistance: [email protected] (909) 591-8431
WATCHMAN Installation Instructions
Fig. 1
Thumb Screw
9V Connectors
90°
135°
Watchman Decal
Fig. 2
Fig. 3
Right End Cap
(Slave Side)
Created on: 06/26/2015
©Alvarado Mfg. Co., Inc.