DM Accessories PROAT Инструкции по сборке и использованию - Страница 2
Просмотреть онлайн или скачать pdf Инструкции по сборке и использованию для Аксессуары для фотоаппаратов DM Accessories PROAT. DM Accessories PROAT 4 страницы. Bottom loading tripod adapter
Печатать страницуAssembly
The longest screw is used as a camcorder hold down screw. It should be inserted into
the vertical plate, then the base plate should be aligned and screwed on using the
shorter screws. The base plate is intended to capture the long screw so it does not get
lost when the camera is removed. The user may choose to put the felt pads on the
corners of the underside of the base plate.
Align and thread screws
Tighten screws with a
screwdriver
Installation
Position the alignment pin of the adapter to the smooth hole on the bottom of the
camcorder while positioning the thumbscrew into place. While keeping the adapter and
camera parallel, tighten down the mounting screw as tight as possible, but by hand only.
Check to be sure the adapter
Tighten thumbscrew
Align pin and thumbscrew
doesn't block the tape door
with camcorder