10 Bar 400D Руководство пользователя - Страница 5

Просмотреть онлайн или скачать pdf Руководство пользователя для Аксессуары для фотоаппаратов 10 Bar 400D. 10 Bar 400D 7 страниц. For canon

groove.

4.7

Mounting the camera in the housing:

Remove the lens cap and wrist strap. The pressure release plug should be pulled out before inserting

the camera. Attach the plastic slide tray to the camera¡s tripod mounting fixture with a coin, screwdriver or the

end of the universal tool supplied (Fig. 5). Take care not to excessively tighten the screw. Slide the camera into

the body along the guide rail (Fig. 6). Make sure the camera body reach the limit and test the function of the

on/of button on the body of the housing. Slide the hot shoe plug into the hot shoe (Fig. 7) Note: If you find that

the buttons do not align properly with the controls, please check again that the camera is properly seated to

the limit of the guide rail.

by internal O-rings. The O-ring on the underside of the plug is just to keep out dirt.

After replacing the lid, make a final visual inspection of the main

O-ring for contamination (Fig. 10).

Note: If the O-ring is in good contact, a thin black line,

about 0.5 to 1mm in width should be visible, where the

O-ring is in contact with the lid. Follow this line all the

way round the edge of the seal, as a final check that the

seal is good. The housing is now ready for the dive.

Important !!!

Before diving, make sure the pressure

release plug is pushed back inside and then screwed

home, do not over tighten this plug (finger tight only).

Replace the lid (Fig. 8). Remember

to ensure the pressure release plug

is pulled all the way out while

closing, otherwise the air cannot

escape. Squeeze the lid closed all

the way with the hissing of expelled

air. Screw home

(CLOCKWISE)

the pressure release plug (Fig. 9).

There is no need to excessively

tighten this plug. The seal is made