AERMEC ANL-H 040 Руководство по установке - Страница 8
Просмотреть онлайн или скачать pdf Руководство по установке для Охладитель AERMEC ANL-H 040. AERMEC ANL-H 040 11 страниц. Chillers; reversible heat pumps; condensing units
Печатать страницу
EN
• SEASON CHANGE controlled from the PR3
• ON/OFF CONTROL from the PR3
Confirm the selection pressing key
and exit the
menu with the key
Once the PR3 remote panel is enabled the change of
season selection can be made directly from the switch
. The unit will automatically switch on and off
with the selected operating mode.
For further information refer to the USER manual.
9.
OPERATING CHARACTERISTICS
9.1.
COOLING SETPOINT
9.2.
HEATING SETPOINT
9.3.
COMPRESSOR DELAY TIMERS
provided:
-
Minimum time from last stop 60 seconds in cooling
mode.
-
Minimum time from last start 300 seconds in heat-
ing mode.
9.4.
CIRCULATING PUMPS
are present the unit will start.
30
9.5.
The alarm
11
To prevent damage to the plate heat exchanger by
an alarm raised if the water temperature drops below
sensor reads a water temperature above 4°C
when the water temperature exceeds 5°C. The water
9.6.
WATER FLOW ALARM
pump.
WARNING
11
can only be adjusted by an
authorised service centre and
only after verifying that the
hydraulic circuit has the cor-
12
If this alarm occurs immediate-
12
. With
ly call the authorised technical
service assistance.
WARNING
FOR 230V/1/50Hz UNITS
The unit is provided with a compres-
-
sor soft starter. This device contains
capacitors that could overheat
through repeated quick starts. If
power supply is removed wait at
least 3 minutes before powering up.
ANL-ANLH 020-202
1608. 6755441_02