DNP DS40 Краткая справка

Просмотреть онлайн или скачать pdf Краткая справка для Принтер DNP DS40. DNP DS40 6 страниц. Photo imaging
Также для DNP DS40: Краткое руководство по эксплуатации (8 страниц), Руководство по переупаковке (2 страниц), Руководство по техническому обслуживанию (6 страниц)

Печатать страницу

DS40 & DS80 Printers

The DS40 and DS80 are quite similar. The

instructions for one will work for the other.

The main difference is in the media width size:

• DS40 printers use 5" or 6" wide media sets.

• DS80 printers use 10" wide media sets.

The easiest way to determine what kind of printer

you have is to look at the label on the front.

ATTENTION:

Always replace paper and ribbon at the same

time.

Installing a Paper Roll

1. Pull out the media

compartment drawer by

lifting the blue handle

under the scrap box and

pulling gently.

2. Release the paper

compartment release lever.

3. Remove the scrap box. Set

it aside.

4. Remove the paper roll from

the printer.

5. Remove the spools ends from the paper roll

by pulling gently on the spools.

6. Set the spools into a new roll of paper.

DNP Imagingcomm America Corporation

DS-Series™ Printer Quick Reference

ATTENTION:

Be sure there is no gap between the paper and

the spools. Failure to set correctly can result

in paper jams. Set the paper into the paper

compartment. Make sure the paper roll is seated

so that the leading edge of the paper roll is

coming over the top of the paper roll and feeding

into the paper compartment from the bottom.

7. Remove the seal on the paper.

8. Advance the paper

so that the paper is

feeding into the printer

from the bottom of the

paper compartment.

The printer beeps when

the paper is in the correct position.

9. Replace the scrap box, and close the top of

the paper compartment.

10. Close the paper compartment.

ATTENTION:

The printer will not operate without the scrap bin

in place.

Installing a New Ribbon

1. Remove the old ribbon and

discard it.

2. Set a new ribbon into the

ribbon cassette. Advance the

ribbon, leaving no slack.

3. Place the cassette in the printer

with the supply side in the front.

4. Close the media compartment

drawer.

5. The printer will cycle through the lights as

it adjusts the media. When the media is

aligned, four blank test images are printed.

Repairing a Ribbon Tear

1. Open the media compartment.

2. Remove the ribbon cassette.

3. Cut the ribbon. Carefully remove any

remaining ribbon from

inside the mechanism.

4. Reattach the ribbon using

cellophane tape, as shown.

5. Advance the ribbon several

times until the tape is no

longer showing.

6. Make sure there is no slack in the ribbon.

Replace the cassette in the printer.

ATTENTION:

Make sure the ribbon is placed in correctly.

7. Close the media compartment drawer. The

printer will re-initialize.

Removing a Paper Jam

1. Pull out the media compartment.

2. Release the paper compartment release

lever.

3. Remove the scrap box. Set it aside.

4. Remove the paper roll from the printer. Pull

any paper remaining from the printer.

5. Cut off any partially

printed, wrinkled or

otherwise inferior paper

evenly with scissors.

6. Replace the paper and feed the paper into

the printer.

7. Replace the scrap box,

and close the media

compartment drawer.

8. The printer will cycle

through the lights as it

adjusts the media. When

the media is aligned, four blank test images

are printed.

Release: v01.2017

PN: 35-260-2-SA