Blue Clean AR 2N1-Q Инструкции по сборке, уходу и использованию - Страница 16
Просмотреть онлайн или скачать pdf Инструкции по сборке, уходу и использованию для Мойка высокого давления Blue Clean AR 2N1-Q. Blue Clean AR 2N1-Q 20 страниц. Electric pressure washer 2050 psi
Печатать страницу
TROUBLESHOOTING
If you have any questions regarding the product, please call customer service at 1-866-235-5112
PROBLEM
Unit will not turn on.
The unit is running
but there is no water
flow.
Why is water leaking
where the high
pressure hose
connects to the spray
gun?
The power washer
turns on for
TROUBLESHOOTING
2 seconds, shuts
off, and will not turn
back on. Do I have a
defective unit?
16
CORRECTIVE ACTION
1. The GFCI module on the end of the power cord must be plugged directly into an outlet.
2. Do not use an extension cord.
3. With the GFCI connected make sure the power switch is turned on.
Note: When power switch is turned on, the power washer will turn on by itself for 1-2
seconds and shut off. This is normal.
1. Power should NOT be turned on until water comes through the spray gun. Doing so will
damage the motor.
2. Check the water source.
3. Eject the nozzle from the lance to determine if clog is coming from the nozzle. (If nozzle
is clogged, see nozzle cleaning instructions under "Cleaning nozzles".)
4. Take off the lance and just spray out of the spray gun. This will indicate if the problem is
with the lance.
5. Check garden hose adapter for loose connection and the filter for debris.
1. Make sure there is an o-ring at the end of the metal tip of the high pressure hose.
If no o-ring is present, the connection between the hose and spray gun will leak. A
Replacement O-Ring Kit is included in your parts. If you require additional O-rings,
O-Ring Kits are available online at www.arblueclean.com or call Customer Service at
1-866-235-5112 to place an order.
1. When the water is connected, the accessories are assembled properly, and the power
is turned on, the power washer may turn on for 1 - 2 seconds to prime the pump. It
automatically shuts off and waits for the spray gun trigger to be pressed. When the
trigger is pressed, water starts flowing through the pump. The water sensor in the pump
"senses" the moving water and automatically turns the power washer on.
2. To perform a "reset". Turn the power switch to off. Hold the trigger on the spray gun so
that you have a steady stream of water. While still holding the trigger, turn the power
switch on.