Dobinsons BU59-3660 & BU59-3510 Руководство по установке - Страница 8
Просмотреть онлайн или скачать pdf Руководство по установке для Автомобильные аксессуары Dobinsons BU59-3660 & BU59-3510. Dobinsons BU59-3660 & BU59-3510 11 страниц. Bullbar toyota hilux vigo 2005 - 2011
Печатать страницу
over riders as they will pull the over riders out
of shape).
25. Fit the new grill bracket (item 10) into place
and refit the grill. The grill tab will locate in
the slot of the new bracket. Place a zip tie
around the rib and the grill and the bracket to
secure tight.
26. Fit the rubber headlight to bumper inserts on
the top of each bar and tighten (Do not over
tighten).
27. With help, fit the bulbar into position and
install nuts and bolts supplied.
28. Align the bar with the vehicle into its correct
position, it is best to sit the grill back in place
so you can align the bar correctly.
29. Once you are happy with the alignment
tighten the 3 nuts and bolts on each side.
30. Once happy with the alignment of the bullbar
drill 2 x 8mm pinning holes on each side of the
bullbar drilling through both the mounting
bracket mounting plate and bullbar mounting
plate. Fix with 8mm bolts and nyloc nuts to
keep the bullbar in its position.
31. If fitting a bullbar with fog lights, the fog lights
can be connected using the original vehicle
fog light wires if fitted. If required, cut the old
fog light wiring plugs off and cut the new fog
light wiring plugs and join. If the vehicle is not
fitted with OEM fog lights the wiring loom
Dobinsons Springs and Suspension
supplied can be used. Follow the wiring
diagram at the end of this manual.
32. Plug the wires into the indicator and parker
light plug. Test all lights and adjust the
position of the fog lights if required
33. Fit the under bar protection kit now with the
bolts supplied.
34. Now cut along the both wheel arch splash
guard so that it is flush with the bottom of the
side protection plate fitting in step 32,
ensuring you do not cut into washer bottle
bracket on the LH side and secure.
35. Check over all nuts, bolts and items removed
during installation.
36. IMPORTANT NOTES: It is important to inform
the customer that headlight adjustment may
also be required due to the change in ride
height. It is also important to inform the
customer that there will be a change in
vehicle handling characteristics. It is also
important to note that due to their nature fog
lights are required to provide a yellow light to
allow clear fog vision. For this reason
Dobinsons bullbars utilise a Halogen bulb.
Halogen bulbs generate a considerable
amount of heat to achieve the yellow colour
and this causes the air inside the fog light lens
to expand and contract. For this reason the
fog light assembly cannot be sealed and has a
small breather on the back. In some cases this
may cause condensation to form inside the
fog light. The customer may choose to seal
the lens of the fog light but must not seal the
rear breather.
www.dobinsonsprings.com