ET&F 610 Руководство по эксплуатации и инструкции по технике безопасности - Страница 11

Просмотреть онлайн или скачать pdf Руководство по эксплуатации и инструкции по технике безопасности для Гвоздезабивной пистолет ET&F 610. ET&F 610 20 страниц.

Печатать страницу

NOTE: Before loading pins in the magazine, adjust the

nail holder. If the magazine cover is forcibly closed

without adjusting the nail holder correctly, the nail

holder may be damaged.

(3) Place the pin coil in the magazine.

Insert the first pin into the magazine opening.

First Pin

(4) Close the magazine cover.

(5) Grip the nail guide and knob with finger.

Press the knob down and swing the nail guide open.

For wire-collated pins

The heads of the row of pins are inserted at guide slot 1

(the upper slot).

The first pin is placed in the ejection port with the second

pin between feed pawl 1 and feed pawl 2.

Ejection port

Magazine

Magazine Opening

Knob

First Pin

Nail Guide

First pin

Guide slot 1

Feed pawl 2

Feed pawl 1

For sheet-collated pins

The heads of the row of pins and the upper extent of the

collating sheet are inserted at guide slot 2 (the lower

slot). The lower extent of the collating sheet is inserted at

the sheet guide slot.

The first pin is placed in the ejection port with the second

pin between feed pawl 1 and feed pawl 2.

Feed pawl 1

First pin

Ejection port

(6) Closing the nail guide

Grip the nail guide and knob with the fingers. While

depressing the knob of the nail guide, rotate the nail

guide to the right until it is completely closed.

(7) Setting the changeover lever

This nailer, as shown in the figure, is able to accommo-

date 6mm pitch wire-collated pins, 8mm pitch wire-

collated pins and sheet-collated pins.

6 mm pitch wire-

collated pins

6 mm

As shown in the diagram, according to the type of pin

used, rotate the changeover lever in the direction of

the arrow until it stops.

If the pitch of the pin to be used is not known, it can be

confirmed by comparing the pins themselves to a

diagram affixed to the reverse side of the magazine.

Sheet-collated

8mm pitch

wire-collated

— 11 —

Guide slot 2

Upper extent of

the collating sheet

Lower extent of

the collating sheet

Sheet guide slot

Feed pawl 2

8 mm pitch wire-

Sheet-collated

collated pins

8 mm

pins

Changeover

lever

6mm pitch

wire-collated

pins