AKOS SQ-100 Руководство по установке - Страница 7
Просмотреть онлайн или скачать pdf Руководство по установке для Крытый камин AKOS SQ-100. AKOS SQ-100 20 страниц. Insert fireplace
− Replacement of the glass should be done by licensed and qualified service personnel. Only
remove glass for routine service. Always handle glass with uttermost care.
− Never use the appliance if the glass panel was removed, cracked or open.
− Do not place any additional imitation logs or glowing coals on the burner or in the combustion
chamber.
− Do not burn solid fuel in the appliance.
− The appliance has been designed for ambience and heating purposes. This means that all surfaces
of the appliance, including the glass, can become extremely hot, hotter than 100 °C, hotter than
boiling water. An exception to this is the bottom of the appliance and the controls, meaning that all
the surfaces, including the glass, are going to be boiling hot, searing and burning and scorching
and injuring the ones brave or unlucky enough to touch the aforementioned surfaces lacking any
protection – thus, it is of paramount importance to prevent children and pets, and for that matter,
anybody, from touching the fireplace glass, a transparent surface hot enough to melt led, in order
to prevent disfiguring injury and horrible tragedy.
− Avoid touching working surfaces of the appliance, such as the glass or any other surface radiating
intense heat, during operation, in order to prevent physical damage. Take care to prevent kids and
animals touching the working surface.
− Do not place any inflammable materials within 0.5 meters of the radiation of the appliance and
ventilation grills.
− Use non-combustible and heat-resistant material for the chimney breast, including the top of the
chimney breast, the material inside the chimney breast, and the back wall against which the
appliance will be placed. For this you can use both sheet material and stone-like materials.
− Take sufficient measures to prevent high temperatures of the wall behind the chimney breast.
− Vent the chimney breast by the means of ventilation holes sufficient enough to evacuate the heat.
− If any electrical connections are to be made, then use heat resistant electric connections and make
sure that they do not make contact with the appliance.
− Use chimneys provided or approved by AKOS.
− Do not cover the appliance or wrap it in an insulation blanket of any other material.
− Make sure that combustible materials have a distance of at least 1000[mm] from the appliance.
− Only use the attached ceramic logs or pebbles set, in accordance to the installation manual.
− The pilot burner must be allowed to burn free without any interruption.
− Make sure that there is no dirt in gas pipes and connections.
− Place a gas tap in accordance with applicable regulations.
− Prior to operating the appliance check for gas leaks.
− Do not, under any conditions, block the explosion valves on the top of the appliance and make
sure that they are not blocked in any manner.
− Due to natural air circulation of the appliance, moisture and volatile components from paint, building
materials, floor coverings etc. that haven't yet set, can be drawn through the convection system and
can be deposited on cold surfaces as soot. That is why you should not use the appliance shortly
after a renovation.
− The first time the appliance is switched on, Let the fire run on maximum setting for several hours so
that the lacquer coating will have an opportunity to set and possible vapors released can be safely
removed by ventilation. We advise you to be outside the room as much as possible during this
process!
Please note that:
•
All transport packaging should be removed.
•
Children or/and pests should not be present in the room.
AKOS Sp. z o o.
ul. Bruszewska 22, 03-046 Warszawa
NIP: 5361925006; REGON 365653140
Tel: +48881697975; email: [email protected]
7 <
<
<
<