DOD SR835 Руководство пользователя - Страница 9

Просмотреть онлайн или скачать pdf Руководство пользователя для Кроссовер DOD SR835. DOD SR835 12 страниц. Dod stereo equalizers owner's manual sr835

SR835 Crossover

Begin sending signal through the system. Gradually increase the High, then Mid,

and finally Low Levels in order checking for correct wiring. Then balance the

tonality of the source signal.You may also need to increase the Gain if a stronger

signal is required.

STEREO USING A MONO SUB-WOOFER

The setup procedure is the same as for the stereo bi amp application, except

that instead of connecting both low frequency outputs, connect only the Low

Frequency Sum output to the low frequency amplifier. Set both Channel 1 and

Channel 2 Low Level controls to the same level to ensure that both controls

contribute the same amount of signal to the Low Frequency Sum output.

MAINTENANCE AND SERVICING

There are NO user serviceable parts inside the units. Opening the chassis will

void the warranty. All service and repair must be performed by the factory or

an authorized service center for the warranty to remain in service.

Should a problem arise with the equalizer, please contact your authorized DOD

Electronics dealer for return/repair procedures.

Frequency Response: 10Hz. to 22kHz +0/-0.5 dB.

THD+Noise: Less than 0.006%.

Signal-To-Noise Ratio: Greater than -90 dB

Filter Type: 18 dB/octave Butterworth state-variable filters.

Crossover Frequencies -

Stereo: LOW/HIGH: 100 Hz to 10 kHz in two ranges. -

Mono: LOW/MID 100 Hz to 10 kHz in two ranges. MID/HIGH 100 Hz to

10 kHz in two ranges.

Input Impedance: 20 k Ω unbalanced, 40 K Ω balanced.

Maximum Input Level: +21 dBu (ref.: 0.775 Vrms).

Output Impedance: 51Ω unbalanced/102 Ω balanced.

Maximum Output Level: +21 dBu (ref.: 0.775 Vrms).

Dimensions: 19"(L) x 5"(W) x 1.75"(H).

Weight: 4.38 lbs.