Dodge SLEEVOIL RTL 7 Руководство по эксплуатации - Страница 3
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Промышленное оборудование Dodge SLEEVOIL RTL 7. Dodge SLEEVOIL RTL 7 12 страниц. Pillow blocks
Печатать страницу
Tighten set screws to value specified in Table 1. Install and
tighten jam screws 1/10 of torque specified for set screws.
Oil shaft in the bearing area and CAREFULLY set shaft in place.
RTL
SLEEVOIL
CLAMP SCREW
SIZE
SCREW SIZE
(SOC. HEX)
3 7/16 RTL
¼ - 20NC
315/16 RTL
¼ - 20NC
4 7/16 RTL
¼ - 20NC
415/16 RTL
5/16 - 18NC
5 7/16 RTL
3/8 - 16NC
6 RTL
½ - 13NC
7 RTL
½ - 13NC
8 RTL
½ - 13NC
9 RTL
5/8 - 11NC
10 RTL
¾ - 10NC
12 RTL
¾ - 10NC
The thrust collar must be centered in the cavity of the liner base.
INSTALLATION OF OIL RINGS
NOTE: Do NOT use oil rings if liner cap has baffles installed
in the oil ring grooves.
Oil rings are shipped disassembled with two extra screws. Place
oil rings around outside of liner base and over shaft.
NOTE: Oil ring halves are match-marked and MUST NOT be
interchanged.
Table 1
THRUST COLLAR
SET SCREW
WRENCH
SCREW SIZE
WRENCH
TORQUE
(SOC.HEX)
TORQUE
(IN.-LBS.)
(IN.-LBS.)
160
5/16 - 24NF
160
5/16 - 24NF
160
5/16 - 24NF
325
5/16 - 24NF
580
3/8 - 16NC
1425
3/8 - 16NC
1425
3/8 - 16NC
1425
5/8 - 11NC
1200
2800
5/8 - 11NC
1200
5000
5/8 - 11NC
1200
5000
5/8- 11NC
1200
Place oil ring around outside of liner base and over shaft.
Install oil ring screws to insure they are secure. Repeat for
second ring.
Make sure oil rings rotate freely on shaft.
INSTALLATION OF THRUST PLATES
For non-expansion bearings:
Clean one set of babbitt faced thrust plates.
NOTE: Thrust plates are shipped in protective wax with the
babbitted faces on the outside. Be careful not to damage
the babbitted faces when peeling off the wax.
NOTE: Plates are matched halves and MUST NOT be
160
interchanged.
160
160
160
275
275
275
Carefully smooth any scratches on babbitted face with crocus
cloth (NOT emery cloth or sandpaper). Oil plate halves generously.
3