Dodge Para-Flex GT Руководство по эксплуатации - Страница 2

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Автомобильные запчасти Dodge Para-Flex GT. Dodge Para-Flex GT 4 страницы.

Печатать страницу

Hex-Head Micro-

Mount Screw

Lockwasher

(1)

Insert bushing into hub. Match the hole pattern, not threaded holes (each complete hole will be threaded on one side only).

(2)

Lightly oil setscrews and thread into those half-threaded holes with the threads in the hub. Do not lubricate the bushing taper, bushing bore, hub

taper or shaft. Doing so could be harmful to the product.

(3)

Position assembly onto shaft allowing for mild axial movement of hub that will occur during tightening procedure.

(4)

Alternately torque setscrews to recommended torque setting as shown in Table 4 below. Be careful to avoid using worn hex key wrenches as they

tend to result in a loose assembly or may damage the setscrews.

(5)

To increase gripping force, hammer face of bushing using a brass drift or sleeve. Do not hit bushing directly with hammer.

(6)

Re-torque screws after hammering.

Section 2a – Dismounting Taperlock Bushing Assembly

(1)

Remove all setscrews.

(2)

Insert one setscrew into any half-threaded hole that is threaded on the bushing.

(3)

Loosen bushing by tightening the setscrew.

Because of the possible Danger to persons or property from accidents which may result from the improper use of products, it is important that correct procedures be followed: Products must be used in

accordance with the engineering information specified in the catalog. Proper installation, maintenance and operational procedures must be observed. The instructions in the instruction manual must be

followed. Inspections should be made as necessary to assure safe operation under prevailing conditions. Proper guards and other suitable safety devices or procedures as may be desirable or as may

be specified in safety codes should be provided, and are neither provided by

installed, adjusted and maintained by qualified personnel who are familiar with the construction and operation of all equipment in the system and the potential hazards involved. When risk to persons or

property may be involved, a holding device must be an integral part of the driven equipment beyond the speed reducer and output shaft.

Section 2 - Taper-Lock Hub Installation

Figure 2: PXGTL Assembly

External Clamp Ring

Locknut

Series

Baldor Electric Company

Elastomeric Element

Table 4

Bushing

Wrench Torque

(in-lb)

1215

175

2012

280

2517

430

Baldor Electric Company

nor are the responsibility of

Hub

Taper-Lock

Bushing

. This unit and its associated equipment must be