DOEPFER A-100 Series Руководство - Страница 3

Просмотреть онлайн или скачать pdf Руководство для Оборудование для звукозаписи DOEPFER A-100 Series. DOEPFER A-100 Series 8 страниц. Analog modular system, connecting the breakout module to the main module
Также для DOEPFER A-100 Series: Руководство по эксплуатации (8 страниц), Руководство (16 страниц), Руководство пользователя (12 страниц), Руководство по сборке и подключению (6 страниц), Руководство (8 страниц), Руководство (6 страниц), Подключение (8 страниц)

doepfer

3. Controls

1 Lev.

Use this attenuator to control the amount of signal

entering the filter input $.

If the filter's output sounds distorted, turn this

control down, unless you deliberately want

the sound as a special effect.

2 Freq.

With this control you adjust the Cut-Off Frequency f

above which the filter attenuates all frequencies. At 10,

the filter is fully open. The more you 'close down' the

filter, the more the high frequencies are filtered (see

Fig. 1): the sound becomes mellower and less bright,

until at 0 the filter is completely shut down, and there

will be no output signal at all.

3 FCV

For voltage control or modulation of the cut-off fre-

quency using CV input § (see Fig. 1), use attenuator

3 to control the level of voltage control.

4 QCV

Attenuator 4 gives you control over the level of vol-

tage control applied to resonance.

System A - 100

Out

Fig. 1: White noise put through a low pass filter

4 QCV

Attenuator 4 gives you control over the level of vol-

tage control applied to resonance.

5 Res.

With this control you adjust the filter's resonance (or

'emphasis') - the parameter which emphasises the

frequencies around the cut-off point f

strengthens or emphasises the band of frequencies

around the filter's cut-off point.

A-105 / A-122

Out

Fre q.

(see Fig. 2). It

Fre q.