E
Warning:
Inside the A-100 cases are dangerous voltages. It is essential to take careful note of the
following safety instructions:
•
Before using any part of the instrument, read these instructions and notes carefully.
•
The instrument may only be used for the purpose described in this operating manual. Due to safety
reasons, the instrument must never be used for other purposes not described in this manual. If you
are not sure about the intended purpose of the instrument please contact an expert.
•
The instrument may only be operated with the voltage specified near the power input on the rear
panel.
•
Before opening up the case or moving a module or blanking panel, always take the mains power
supply plug out. This applies also to removing or replacing any panel or module.
•
All empty spaces in the rack must be filled with modules or blind panels before the unit is
connected to mains voltage.
•
The instrument must never be operated outdoors but only in dry, closed rooms. Never use the
instrument in a humid or wet environment nor near inflammables.
•
Do not use this instrument in damp environments, or close to water.
•
No liquids or conducting materials must get into the instrument. If this should happen the
instrument must be disconnected from power immediately and be examined, cleaned and
eventually be repaired by a qualified person
•
Do not use this instrument in close proximity to heat sources such as radiators or ovens. Don't
leave it in direct sunlight.
•
This instrument must be assembled or installed in a way that guarantees sufficient ventilation and
air circulation.
•
The instrument must not be exposed to temperatures above 50°C or below -10 °C. In use, the
instrument must be at a minimum temperature of 10 °C.
•
In case of an A-100G6 case: keep the top side of the instrument free in order to guarantee proper
ventilation, otherwise the instrument could be overheated. Never place heavy objects on the
instrument.
•
This instrument can, without any external amplification or in combination with a headphone or
speaker amplifier, produce sound levels which can damage your hearing. Don't work at high sound
levels for prolonged periods of time, and don't ever use levels which cause discomfort.
•
The instrument's mains power supply lead should be disconnected if it is not used for any
substantial period. If there is any damage the cables must be repaired or replaced by an authorized
person
•
Do not tread on the mains supply lead.
•
In disconnecting the lead, pull the plug, not the cable.
•
If this instrument is connected to others, check in their manuals for connection instructions.
•
Make particularly sure that no object falls into the instrument, and that no liquid gets into it.
•
Transport the instrument carefully, never let it fall or overturn. Make sure that during transport and
in use the instrument has a proper stand and does not fall, slip or turn over because persons could
be injured
2
Печатать страницу