Doepke 09501146 Руководство по эксплуатации - Страница 6
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Блок управления Doepke 09501146. Doepke 09501146 8 страниц. Shutter control unit
Печатать страницу
Doepke
9. Putting into Service
Only an authorized expert is allowed to carry out the installation. When installing, the
connection diagram has to be observed. All conductors that shall be connected have to
be free of voltage. Following table shows the connections:
Terminal
1.1/1.5
Motor 1 output (UP/DOWN)
2.1/2.5
Motor 2 output (UP/DOWN)
3.1/3.5
Motor 3 output (UP/DOWN)
4.1/4.5
Motor 4 output (UP/DOWN)
1.3
Dupline signal conductor -
(Dupline-)
1.4
0 VDC operating voltage
Short circuits between Dupline signal conductors and the 24 V operating voltage or con-
nections to the grounding lead to malfunction and are not allowed. The correct polarity
of operating voltage and Dupline signal conductors has to be ensured.
In order to meet the requirements for protective low voltage, VDE 0100, Part 410, should
be observed and put into practice during installation.
When connecting please observe that the maximum torque of the terminals of 0.6 Nm
will not be exceeded.
The patented click-and-lock-mechanism allows an easy removal of the unit from the rail
by pushing the housing upwards until it is released.
10. Indicators
Indicator
Green "BUS OK"
LED
4 red LED „AUF"
4 red LED „AB"
11. Technical Data
Dupline
Input channels None
Output channels 8 control channels (shutters 1/2/3/4, each „Up" und
Outputs
6
Description
Dupline bus:
Off - bus fault / On - bus OK
All-or-nothing relay 1 / 2 / 3 / 4:
Off - no upward movement / On - upward movement
All-or-nothing relay 1 / 2 / 3 / 4:
Off - no downward movement / On - downward movement
Current input
„Down")
Type All-or-nothing relay
Voltage
Terminal
1.2/1.6
2.2/2.6
3.2/3.6
4.2/4.6
1.7
1.8
Description
Min.
3931210/03/05/E
Description
Phase input motor 1 (L
Phase input motor 2 (L
Phase input motor 3 (L
Phase input motor 4 (L
Dupline signal conductor + (Du-
pline+)
+24 VDC operating voltage
Typ.
10 µA
230 VAC
)
IN1
)
IN2
)
IN3
)
IN4
Max.