Canoga Perkins L357 ESU Краткое руководство по эксплуатации - Страница 4

Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Сетевой маршрутизатор Canoga Perkins L357 ESU. Canoga Perkins L357 ESU 8 страниц.

Печатать страницу

Figure 6. L357 in UCS 1030 customer premise enclosure

Step 4: Applying Power

When installing the module in an enclosure, power up the device by inserting a power cord to an

AC outlet. During the boot-up process, which may take up to 40 seconds, the LEDs will turn

amber and the STA LED will flash amber until the boot-up process is complete. If the switches

are set to the default setting, the STA LED will light up red, SPD amber and FDX green after the

boot-up process. All other LEDs on the module are off.

Step 5: Management Access

To access the user interface of the L357, a VT100 session must be created through

HyperTerminal or a comparable VT100 terminal. When accessing the management interface

through, connect a DB-9 EIA-232, straight cable from your PC or laptop (COM 1 or any open

COM port) to the EIA-232 port of the UCS 1020 or DMM. Accessing the management interface

through the 1230 BAM requires a DB-9 to RJ cable available through Canoga Perkins, p/n CRJ-

D9F-10.

Create a HyperTerminal session from your laptop or terminal through the

Programs/Accessories/Communications/HyperTerminal menu.

Figure 7. Accessing HyperTerminal

Canoga Perkins Corporation, 20600 Prairie Street, Chatsworth, CA 91311-6008

Phone: (818) 718-6300, FAX (818) 718-6312 www.canoga.com

P/N 6942590 Rev A

Page 4 of 8