Dogtra EF3000 Руководство пользователя - Страница 10
Просмотреть онлайн или скачать pdf Руководство пользователя для Средство для ухода за домашними животными Dogtra EF3000. Dogtra EF3000 18 страниц. Remote controlled dog training collars
Также для Dogtra EF3000: Руководство по эксплуатации (14 страниц)
Печатать страницу
TESTING
TESTING YOUR
PRIOR TO INSTALLATION
1. To ensure that your
connect the transmitter adaptor into the adaptor of the transmitter and
then plug the adaptor into a household outlet. Switch the stimulation
knob to Pager+Stimulation, or Stimulation Only. The ON/OFF
indicator light should turn on.
2. Unwind the length of ground wire that was provided and strip about 1/2
inch off each end. Insert both ends of the ground wire into the outer, red
wire connector jacks, leaving the center jack free. If the wires are
connected properly, the wire indicator light will be on.
3. Next, activate the receiver/collar by turning the intensity level dial on
the receiver to the desired level. The LED light will blink once every
two seconds showing that it is on.
If not activated for 10 seconds or more, the system will go into sleep
mode.
4. Hold the receiver in your hand with the contact points facing up. Place
the test lamp over the contact points and approach the test loop.
5. Watch for the test lamp to come on and/or the unit will emit the
warning vibration if the unit is in this mode at the wall mount
transmitter. Be careful not to touch the contact points as the unit will
emit stimulation when activated.
16
system is working properly,
INSTALLATION
Fence Wire
The fence wire must make a continuous loop around your property for
your system to operate. The signal is delivered from the terminal of the
transmitter, through the fence wire, back to the other terminal on the
transmitter. When this is accomplished, the wire continuity light will emit
a constant red indicator.
INSTALLATION
17