Akrobat GALLUS Руководство по установке и эксплуатации - Страница 8
Просмотреть онлайн или скачать pdf Руководство по установке и эксплуатации для Спорт и активный отдых Akrobat GALLUS. Akrobat GALLUS 14 страниц.
Печатать страницуThe final step of the trampoline installation is
16*
attaching the bottom PVC skirt (part W) around
the frame of the trampoline and anchoring the
trampoline to the ground.
Start by attaching the skirt with the Velcro
around the frame under the door.
Then take the black cord (part T) and attach
17
the top of the skirt to the net through the holes
on the net and the eyelets on the PVC skirt,
starting right from the door.
Place the ladder and the shoe mat under the
18
door and you are all set to jump!
Instructions specific for Gallus 10 ft
After
assembling
the
trampoline
3*
continue by joining the legs with the frame
parts. Start by adding the triangular frame
part with double junction part (part A1 to part
F1) to the frame and continue with adding
the leg extension (part F1 to part D1). This is
the part where the safety net pole will be set.
Make sure the free part of the junction part is
turned to the outside of the frame circle.
Continue assembling the frame, alternating
the frame parts with and without sockets to
form the frame circle.
Continue by fitting the jumping mat and attaching the frame pads as described on the previous pages.
14
INSTALLATION AND USER MANUAL - GALLUS
At the end, secure the bottom part of the pvc skirt with
the remaining elastic cord and tie it around the legs so as
to prevent the skirt from moving.
legs,
Installation of the safety net
Start assembling the safety net by inserting the
8*
enclosure pole attached to the door into the
triangular frame part with T-socket.
Insert the bottom part of the enclosure door
and start unrolling the safety net around the
mat. Make sure the net is not twisted. After
unrolling the entire net, insert the final pole in
the socket next to the door.
Important:
Be sure to close the safety net door
on the inside of the trampoline
before inserting the last pole into the
junction part.
Continue with step no. 9 as described on the page 12.
After installing all the poles, start assembling
11*
the top frame. Attach two top rail poles (part G1)
together, take a connector screw (part P) and
tighten the connector screw into the top of
the enclosure pole.
One of the top rail poles has an additional
through-hole to accommodate the door
(part D1). This pole should be attached above
the door and tightened with the connector
screw into the top of the enclosure pole.
Continue by attaching two top frame parts
together, then taking a connector screw and
tightening it into the top of the enclosure pole.
Important:
There are two sizes of top frame parts
– alternate them according to the
frame legs above which the longer
top frame parts should be placed.
Continue with step no. 14.
15