DogWatch CAT200 Инструкция по эксплуатации - Страница 4
Просмотреть онлайн или скачать pdf Инструкция по эксплуатации для Средство для ухода за домашними животными DogWatch CAT200. DogWatch CAT200 4 страницы.
Печатать страницу
Troubleshooting
If your pet enters the signal field without responding to the correction signal, make sure that both the
transmitter and the receiver collar are "on" and working. If both the transmitter and the receiver are
functioning properly, you may need to increase the signal range on the transmitter (or the wire) or increase
the correction level on the collar.
Reminder: Never adjust the transmitter or the correction level while your pet is wearing the receiver collar.
Receiver
•
Check to see if the transmitter is turned 'on'.
•
Take the receiver collar off the cat and check the receiver by placing the test light on the contact posts
while holding the receiver next to your wireless transmitter or the boundary wire. If your test light lights
up, your receiver is working properly. Be sure not to touch the contact posts.
•
Make sure the collar fits and the contact posts on the receiver actually touch your pet's skin.
•
Be sure the receiver battery is inserted correctly.
•
Replace the battery as needed. Battery life for the CR7 cat receiver is typically 6 months.
Transmitter
•
Check to see if the transmitter is plugged-in and receiving power. Make sure that the power is not
turned-off at a light switch or elsewhere. If functioning properly, the status light should be green (solid
green or blinking green depending on the Frequency setting.)
•
Make sure the transmitter INT/EXT switch on the back of the transmitter is correctly set for 'Wired' (ext)
or 'Wireless' (int) use.
•
If using a wire, make sure the wire is properly separated to create a signal field and make sure the ends
of the wire are stripped and twisted together to create a continuous loop.
•
Check the Range Setting on the back of the transmitter. Increase the range if necessary. Too small a signal
field may allow your pet to get too close to the boundary area before receiving a warning.
To see warranty information and submit Warranty Registration: www.dogwatch.com/support
This device complies with part 15 of the FCC Rules and with Industry Canada rules. Operation is subject to the following conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
Le présent appareil est conforme à la partie 15 régles FCC et est confirme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux conditions suivantes: (1) l'apppareil ne doit pas produire de brouillage, et (2) l'utilisateure
de l'appariel doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
DogWatch products are lead-free and compliant with the Reduction of Hazardous Substances (RoHS) initiative.
DogWatch Products are protected under U.S. Patent numbers: 6,360,698; 6,467,435; and 6,825,768
©2020 DogWatch Inc. All rights reserved.
2 Year Warranty
4
295xxx Rev. A 04-20