Aseptico 6520-01-456-5406 Руководство по эксплуатации и техническому обслуживанию - Страница 4
Просмотреть онлайн или скачать pdf Руководство по эксплуатации и техническому обслуживанию для Внутренняя отделка Aseptico 6520-01-456-5406. Aseptico 6520-01-456-5406 8 страниц. Portable dental stools
Также для Aseptico 6520-01-456-5406: Руководство по эксплуатации и список деталей (12 страниц)
Печатать страницу
STOOL SET-UP:
1. Remove the stool from its carrying case and
swivel the back support to the upright position.
(Fig. 1)
2. Turn the ADC-08CF Stool upside down and set
on the edge of an elevated flat surface such as a
table or counter top. Scissor the leg frame so
that the frame cross member lines up with the
stop channel at the rear of the stool on the
underside. Fit the frame cross member into the
channel and push firmly into place. (Fig. 2)
3. Extend the legs to the proper height by pulling
the adjustable legs out of the frame. The
adjustable legs are marked with a red height
indicating dot. Pull the leg out until the red dot
is just exposed and rotate until red dot is in line
with the holes in the frame tube. The spring
loaded adjustment pin should then pop through
the frame hole and lock leg into place. (Fig. 3)
Repeat for all other legs.
4. Once you have set the legs to the proper height,
turn the ADC-08CF Stool upright and set on a
hard, flat surface for use.
MAKE SURE ALL LEGS ARE
EXTENDED TO THE SAME HEIGHT.
NEVER SIT ON THE EDGE OF THE
SITTING SURFACE. ALWAYS SIT IN
THE CENTER OF THE SEAT.
COLLAPSING THE STOOL:
Reverse the set-up procedure to collapse stool for
packing. When collapsing the stool, depress spring
loaded adjustment pin and turn adjustable leg 90
degrees before pushing leg into frame. This will
prevent the legs from stopping at every adjustment
interval.
CLEANING AND MAINTENANCE:
The stool upholstery and frame may be wiped down
with water or a mild detergent solution. Sterilize
using a bleach/water solution.
Page 4
WARNING
Figure 1 - Backrest Positioning
Figure 2 - Securing Leg Frame