ASG EasyLine 4G Руководство по установке и эксплуатации - Страница 5
Просмотреть онлайн или скачать pdf Руководство по установке и эксплуатации для Блок управления ASG EasyLine 4G. ASG EasyLine 4G 16 страниц. Miniature phone line (pstn) simulator
Печатать страницу
Installation guide
Technical parameters
•
Power voltage: 9-24 VDC
•
Simulated voltage: 48V (line), 72V (ringing)
•
Standby power drain: 80 mA
•
Maximum power drain: 1000 mA
•
Open Collector output load: max. 30V/300 mA
•
GSM module type: SIMA7672
•
GSM frequency: GSM 850 / EGSM 900 / DCS 1800 / PCS 1900 (Multi- Band)
•
SIM card usage: brand free GSM module
•
GSM antenna type: SMA connector (comes with package)
•
Dimensions: 62 x 42 x 16 mm, packed: 132 x 128 x 32 mm
•
Operation temperature: -20°C - +50°C
Installation steps
1. Carry out a signal strength check with your mobile phone. Sometimes occurs there is no sufficient signal
strength at the commissioning site. In this case it is recommended to change module position prior to
installation.
Do not install the device to places where strong electromagnetic waves might occur, ex. next to electric
motors or alarm transformers!
Do not install in watery places or in places with great humidity!
2. Connecting the antenna: antenna can be secured with an SMA connector. If you are reading low signal
strength use antenna with higher gain. Signal strength grow can also be achieved by repositioning the
antenna.
Do not position the antenna under various metal covers as those might significantly ruin the
signal strength!
3. You should opt out the SIM card PIN number request, voicemail and call notification!
Sometimes new SIM cards must be activated (usually an outgoing call has to be made). Check the validity of
the card. If you have a prepaid card check its balance and its usage possibilities (ex. calls only)
4. It is practical to check the satisfying operation of a SIM card in a cell phone prior of insertion into a module.
At this step it is practical to also save controlling telephone numbers on the SIM card. Number identifying
at the caller and the called has to be checked. At certain service providers this function must be enabled
formerly.
5. Insert the SIM card in the SIM card slot of the module.
6. Connectors have to be connected according to the wiring diagram. If you are dealing with OC output mind
the correct wiring of the relay protecting diode.
7. If you are working with OC relay be cautious especially in avoiding electric shocking. A proper contact
protection must be established. If you are not qualified ask for professional help.
8. Check if the power supply performance will be sufficient for the module. Mind the polarity.
If wiring is reversed the module will not operate or might get damaged.
9. Now the device can be powered.
10. After connecting the voltage supply the red LED is lighted indicating the device establishing connection
with the GSM system (this can be 1 minute utmost).
11. If red LED goes off and green LED is blinking module is online and connected to network. The blinking
number(s) indicates GSM signal strength.
The power supply must be connected for programming!
EasyLine 4G
www.ascglobal.eu
5