Doka Framax stripping corner I 3.30m Оригинальная инструкция по эксплуатации - Страница 4
Просмотреть онлайн или скачать pdf Оригинальная инструкция по эксплуатации для Строительное оборудование Doka Framax stripping corner I 3.30m. Doka Framax stripping corner I 3.30m 18 страниц.
Печатать страницуAssembly
NOTICE
▪
Stripping cylinders must always be fully
retracted for installation.
▪
It is not permissible to install the stripping
cylinder on a stripping corner that does not
have a hole for the locking pin!
This hole is a standard feature of all strip-
ping corners manufactured from 2005
onward.
9239-200-11
▪
To prevent abrasion or trapping damage,
the hydraulic hoses must be secured to the
neighbouring formwork panel and properly
laid and arranged. Tight bending radii
should be avoided.
➤
Carefully lay the stripping cylinder on its side.
➤
Remove Spring cotter 5mm and Connecting pin
10cm.
➤
Remove the adapter from the cylinder.
➤
Remove both pins D17.5.
B
A
9239-208-01
A Spring cotter 5mm
B Connecting pin 10cm
C Adapter for Framax stripping corner I
D Pin D17.5
➤
Push the adapter into the pushrod of the stripping
corner and pin it into position with two pins D17.5.
C
E
F
C Adapter for Framax stripping corner I
D Pin D17.5
E Push-rod
F Framax stripping corner I
4
C
D
D
9239-200-05
Original Operating Instructions Framax stripping corner I hydraulic
NOTICE
It is not permissible to install the adapter in the
pushrod with only one pin D17.5
➤
Place the stripping cylinder on the centring stud of
the stripping corner.
G
H
G Framax stripping cylinder I
H Centring studs of stripping corner
I
Assembly plate
The centring studs must be seated in the recesses of
the assembly plate.
➤
Twist the stripping cylinder clockwise until fully
engaged.
G
G Framax stripping cylinder I
H Centring studs of stripping corner
➤
Push the locking pin into the hole in the stripping cor-
ner.
J
9239-200-09
J Locking pin
Note:
The locking pin acts as anti-twist lock for the stripping
cylinder.
I
9239-200-04
H
9239-200-03
999239002 - 07/2018