CYP OR-HD44E Руководство по эксплуатации - Страница 8
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Матричный коммутатор CYP OR-HD44E. CYP OR-HD44E 12 страниц. 4 by 4 hdmi v1.3 matrix
Печатать страницу
7.2 Rear Panel
RS-232
D
①
① . RS-232 communication port: Connect the COM port of your PC for the
distant control over RS-232 channel. Detail Specifications in section 8.
② . HDMI outputs: Connect each of these output ports to the HDMI display(s).
The device supports repeater function and each output port can supports
16 key sets of KSV and 4 outputs can support a total of 64 key sets of KSV.
③ . IR IN: Place the IR receiver cable in front of the displays and then using
sources remote control to control sources through IR receiver cable.
④ . 8/12 bits switcher – Supports 8 or 12 bit ' s deep color function. This selection
is only available when EDID is in STD mode.
Note:
When HDMI output has both 8-bit and 12-bit displays, to ensure all output
will display, switch to 8-bit is imply with the first HDMI output of 8 bit ' s
displayer. On the other hand, when all output are with the same bit ' s
displayer of 12-bit or 8-bit then switch the function to 12-bit or 8-bit will be
proper. The splitter will not function according to different bits ' of display
on HDMI outputs simultaneously.
⑤ . EDID Control Switcher: Default factory setting is TV, leave as it is when
the displays are working properly. Switch to STD to use built-in EDID.
Note:
1. STD means internal EDID, TV means external EDID.
2. When EDID swtich to TV, the unit will detect the first DVI output source's
EDID and record in the unit. If the first detected output source is HDMI it
will pass to next source, until the first DVI been detected. The detection
priority is HDMI v1.3 < HDMI v1.2 < DVI.
3. When EDID is on STD: unit use built-in EDID
Video Support ->1080p 12-bit (max)
Audio Support ->PCM2.
4. EDID switching during display will cause image pause do to EDID
resetting and image re-position.
⑥ . Power: Plug the 5VDC power supply into the unit and connect the
adaptor to AC wall outlet.
HDMI OUTPUT
C
B
②
IR IN
A
③
5
DC 5V
8 Bit
12 Bit
STD
TV
④
⑤
⑥