Dolby Laboratories CP750 Руководство по установке - Страница 10
Просмотреть онлайн или скачать pdf Руководство по установке для Компьютерное оборудование Dolby Laboratories CP750. Dolby Laboratories CP750 19 страниц. 7.1 audio for the dolby multichannel amplifier
Печатать страницу
- 1. Introduction to Dolby Cp750 7.1 Audio for the Dolby Multichannel Amplifier
- 2. About the Cp750 (or Other Cinema Processor) Configuration for the
- 3. Connecting a Cp750 (or Other Sound Processor) to a Media Block
- 4. Configuring Advanced Connections
- 5. Cp750 Audio Output Cable Pinouts
- 6. To 25-Pin D-Connector Digital Audio Pinouts
About this task
You need to interconnect a CP750 (or other cinema processor), Dolby Multichannel Amplifier
(with version 2.0.x.x software), Yamaha Tio1608-D, media block, your computer, and a network
switch.
Procedure
1. Connect the AES3 output from a Dolby IMS2000 (or other cinema media block) channels 1-8
RJ-45 port to the CP750 (or other cinema processor) 4×AES IN port using an RJ-45 to male
25-pin D-connector audio adapter.
2. Connect the analog output from the CP750 (or other cinema processor) to the Yamaha 8 ×
analog inputs through a 25-pin D-connector to 8 × XLR audio cable. The optional Dolby
accessory kit, DMA-ACC-YAM-ADC, provides this cable.
The XLR ends of the cable are marked with the channel information. Here is a typical routing
configuration:
1 = Left
2 = Right
3= Center
4 = Low-Frequency Effects/subwoofer
5 = Left Side Surround
6 = Right Side Surround
7 = Left Rear Surround
8= Right Rear Surround
If you want purchase a cable from another source, or build your own cable, refer to the
pinouts and cable specifications.
3. Set your computer to DHCP or to link local IP.
4. Connect your computer to the network switch.
When connected directly without a DHCP server, your computer and the Yamaha device
select link local IP addresses (169.x.x.x), and can communicate with each other using the
Dante Controller autodiscover capabilities.
Related information
Pinouts
on page 18
3.3 Using the Dante controller for the AES67 setup
To transmit AES67 output from a CP750 (or other cinema processor) via the Yamaha Tio1608-D
to the Dolby Multichannel Amplifier, you need to use the Dante Controller software to set up
routing for the Yamaha Tio1608-D.
Procedure
1. Launch the Dante Controller software application on a computer that is attached to the same
network as the Yamaha Tio1608-D (A Microsoft Windows system is used in these examples.)
The Network View window appears.
Dolby CP750 7.1 audio for the Dolby Multichannel Amplifier Installation Manual
7 May 2018 Issue 1
Setting up the system
10