Ashford Jack Loom Руководство по эксплуатации - Страница 13

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Вращающиеся колеса Ashford Jack Loom. Ashford Jack Loom 16 страниц.

25. Rub candlewax on the ends of the

shafts before loading them into the

nylon guides. Load the shafts and

locate the jack pin into the centre

hole in the shaft. If any of the shafts

are curved, to avoid them touching,

load them so that the curves are all

in the same direction.

26. Attach the castle top rails T to the

castle sides E and EX with

. Locate the shelf V onto the

Screws

castle. It is easily removable for

access to the shafts.

Important: Make sure the ends of the

top rails are flush with castle sides.

If not the shafts can be tight in the

nylon guides.

27. Locate the front and back beams Y onto the tenons of uprights C, CX and D, DX. The beams are easily removable to allow

access to the shafts when warping.

NOTE: The back beam has a built in raddle with 10mm spacing. Fit the beam with the raddle pins facing up when warping,

otherwise fit it with the raddle facing down. Use the wooden cover strip to keep your warp in place.

8 x 1½

Screws