Cypress CY3633 Руководство пользователя - Страница 12

Просмотреть онлайн или скачать pdf Руководство пользователя для Микроконтроллеры Cypress CY3633. Cypress CY3633 20 страниц. Wirelessusb ls gaming dvk

WirelessUSB™ LS Gaming DVK User's Guide

2.3 Auto-Bind Operation

Out of the box, both gaming systems are configured to auto-bind. Additionally, the Game Control-

ler is enabled to sleep if the connection is lost. Binding is performed by simultaneously pushing the

Bind button on both the receiver Platform Board and the Game Controller Platform Board. The

Bind button is located at the top of the Platform Board close to the radio module.

After power has been applied to both the receiver and controller as described in Section 2.1 and

Section 2.2, perform the following steps:

1. On the Game Controller, press any button on the keypad to wake up the controller.

2. Once the controller is awake, press and release the Bind buttons on both boards simulta-

neously. Observe that the red Bind LED is on.

3. The receiver and controller will then attempt to bind and establish a connection.

4. If the Bind procedure is successful, the Connect LED on the Game Controller will begin to

blink.

5. If the Bind LED stays on for more than approximately 10 seconds, that indicates that the Bind

was unsuccessful. Reset both boards, by pressing the reset button located just to the right of

U3, and then go to step 1 to try again.

If successful, the binding process only needs to be done once. The settings are saved in FLASH

memory, and the connection will automatically be re-established when the system is powered up.

PS2 configuration only: If for some reason the radio module is replaced with another radio mod-

ule, the FLASH memory will need to be reset in order for the auto bind parameters to be regener-

ated correctly based on the new radio ID. To reset the FLASH memory Press and hold the '-'

(Reset Factory) button while pressing and releasing the reset button 'S1' located next to U3. This

procedure should be done on both the dongle and the game controller. The bind process previ-

ously described will then need to be performed.

Page -8

WirelessUSB™ LS Gaming DVK User's Guide Rev 1.1